Sony Xperia XA2 Ultra Headphone Jack Replacement

はじめに

If the Sony Xperia XA2 Ultra is not showing any sign of being connected to a set of corded headphones or an auxiliary cord, then the headphone jack might need to be replaced.

Before taking any steps to open the phone, make sure that it is turned completely off.

Be aware that when using a heat gun (or something similar) that the device will heat up. Continue with caution.

必要な工具と部品

手順1 Rear Cover

Sony Xperia XA2 Ultra Headphone Jack Replacement, Rear Cover: 手順 1、 2の画像 1

Sony Xperia XA2 Ultra Headphone Jack Replacement, Rear Cover: 手順 1、 2の画像 2

Turn off your phone before continuing.
Remove the SIM card tray on the left side of the phone using a SIM card eject tool.

編集

手順2

Heat the edge of the phone with the heat gun (recommended) for 30 seconds.
If you don't have a heat gun, a hair dryer can be used.
Use the hair dryer on the highest setting, constantly going around the phone to heat all of the edges.
The phone will become hot to the touch. Use gloves or a towel to touch the phone.

編集

手順3

Apply the suction handle near an edge of the phone and pull upwards while trying to get an opening large enough for an iFixit opening pick.

編集

手順4

Pry upwards with the pick to start pulling the rear cover off the adhesive it’s attached to.
Insert a second pick once there is enough room.

編集

手順5

Take one of the picks and try to slide it down the side of the phone, pulling more of the cover off the adhesive.
The iFixit opening tool may also be used to gain better leverage.
The rear cover will pop off.