Tools you will need is the Phillips #00 precision screwdriver, Plastic Opening Tools, and tweezers. Insert plastic opening tool in the corner of device and slide along edges to separate adhesive Remove cover
  • Tools you will need is the Phillips #00 precision screwdriver, Plastic Opening Tools, and tweezers.

  • Insert plastic opening tool in the corner of device and slide along edges to separate adhesive

  • Remove cover

コメントを追加する

Locate the SD card reader in the bottom left hand corner
  • Locate the SD card reader in the bottom left hand corner

  • Remove all screws connecting the metal plate to the device.

コメントを追加する

After all the screws have been removed lift the circuit board up to wiggle free.
  • After all the screws have been removed lift the circuit board up to wiggle free.

コメントを追加する

After Wiggled free place the tweezers on the piece of electrical tape connecting it to the device.
  • After Wiggled free place the tweezers on the piece of electrical tape connecting it to the device.

  • Once placed there lift up and disconnect the SD card reader from the device.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Martin Luna

メンバー登録日: 2014年09月24日

1,504 ポイント

5のガイドは作成済み

チーム

USF Tampa, Team 15-6, Remmell Fall 2014 USF Tampa, Team 15-6, Remmell Fall 2014人のメンバー

USFT-REMMELL-F14S15G6

3 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 11

過去 30 日: 24

今までの合計 1,387