メインコンテンツにスキップ

Sony Walkman NWZ-E438 USB Port Replacement

必要な工具と部品

  1. Sony Walkman NWZ-E438 USB Port Replacement, Disassembling Sony Walkman NWZ-E438: 手順 1、 1の画像 1
    • Unscrew the two screws on the back of the device using a Phillips PH000 screwdriver.

    • Keep the Phillips PH000 screwdriver aside for further steps in the guide. It will be the only screwdriver needed for this replacement.

  2. Sony Walkman NWZ-E438 USB Port Replacement: 手順 2、 1の画像 1
    • Use a small prying tool to carefully pry open the back of the device.

  3. Sony Walkman NWZ-E438 USB Port Replacement, Circuit Board: 手順 3、 3の画像 1 Sony Walkman NWZ-E438 USB Port Replacement, Circuit Board: 手順 3、 3の画像 2 Sony Walkman NWZ-E438 USB Port Replacement, Circuit Board: 手順 3、 3の画像 3
    • First, you must remove the black tape on the circuit board.

    • Next, pull up on the red and gold band until it detaches from the chip.

  4. Sony Walkman NWZ-E438 USB Port Replacement: 手順 4、 2の画像 1 Sony Walkman NWZ-E438 USB Port Replacement: 手順 4、 2の画像 2
    • Using a small plastic prying tool, slip the end under the device circuit board and slowly lift it.

    • Once the circuit board is lifted, carefully remove the chip with tweezers.

    • The circuit board will still be connected to the device by a wire.

  5. Sony Walkman NWZ-E438 USB Port Replacement: 手順 5、 1の画像 1
    • Using a soldering iron, carefully heat the metal connecting the wires from the device to the circuit board.

    • You will need the soldering iron to reattach those wires once you've replaced the circuit board.

  6. Sony Walkman NWZ-E438 USB Port Replacement: 手順 6、 1の画像 1
    • Carefully remove the circuit board from the device.

  7. Sony Walkman NWZ-E438 USB Port Replacement, USB Port: 手順 7、 1の画像 1
    • Using fine point tweezers, push them between the chip and USB port.

  8. Sony Walkman NWZ-E438 USB Port Replacement: 手順 8、 1の画像 1
    • Slowly pry the USB port off of the chip.

    • You will need to solder the new USB onto the circuit board.

  9. Sony Walkman NWZ-E438 USB Port Replacement: 手順 9、 1の画像 1
    • Remove USB port.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

3人の作成者と共同で作成されました。

Cheryl Zinn

メンバー登録日: 10/08/15

525 ポイント

5のガイドは作成済み

チーム

Eastern Washington University, Team 2-5, Plummer Fall 2015 Eastern Washington University, Team 2-5, Plummer Fall 2015人のメンバー

EWU-PLUMMER-F15S2G5

4 メンバー

6のガイドは作成済み

コメント 1 件

Wher buy new port????pavel87cz@gmail.com

Pavel Drobny - 返信

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 585