メインコンテンツにスキップ

パーツ

パーツは指定されていません。

  1. Begin by opening the HDMI/USB port cover on the left edge.
    • Begin by opening the HDMI/USB port cover on the left edge.

    • Remove the three #000 headed, 3 mm long screws located underneath the port cover.

  2. Locate and open the Micro SD slot on the top side of the device.
    • Locate and open the Micro SD slot on the top side of the device.

    • Remove the two screws located beneath the cover.

  3. Attach the suction cup to the top right area of the screen. Pull to separate the screen from the rest of the device.
    • Attach the suction cup to the top right area of the screen.

    • Pull to separate the screen from the rest of the device.

    • Be aware of the front camera cable that is still connected to the rest of the device.

    • Detach the display ribbon cable.

  4. Disconnect the battery from the motherboard by pulling out the cable below the fan.
    • Disconnect the battery from the motherboard by pulling out the cable below the fan.

  5. Remove the seven 3 mm Phillips #000 screws that hold the battery in place.
    • Remove the seven 3 mm Phillips #000 screws that hold the battery in place.

    • Carefully remove the battery from the back assembly.

  6. Remove the nine 3 mm Phillips #000 screws holding in the motherboard.
    • Remove the nine 3 mm Phillips #000 screws holding in the motherboard.

  7. Remove the black plastic dust shield by gently pulling it up.
    • Remove the black plastic dust shield by gently pulling it up.

    • You'll want to keep the sticky side up so you can replace it when reassembling. This part also functions as a shield for the sensitive camera component!

  8. Before removing the motherboard, there are a few cables to disconnect. Disconnect the cable connected to the top of the display. Disconnect the power jack connector on the left side of the screen.
    • Before removing the motherboard, there are a few cables to disconnect.

    • Disconnect the cable connected to the top of the display.

    • Disconnect the power jack connector on the left side of the screen.

    • Disconnect the daughterboard connector located above and to the right of the WiFi chip slot.

  9. Gently pull the motherboard out by pulling from the right side of the board and flip it so that the motherboard now sits where the battery was and the underside is now visible. There is still one cable to remove!
    • Gently pull the motherboard out by pulling from the right side of the board and flip it so that the motherboard now sits where the battery was and the underside is now visible.

    • There is still one cable to remove!

    • Remove the speaker connector located next to the SSD slot.

    • You may now remove the motherboard from the device.

  10. Once the motherboard is out of the device, removal of the camera module is simple.
    • Once the motherboard is out of the device, removal of the camera module is simple.

    • Pull out the ribbon connector from the motherboard next to the module, then remove the camera module.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Alexander Bridges

メンバー登録日: 2015年09月16日

1,166 ポイント

7のガイドは作成済み

チーム

IUPUI, Team 1-2, Harley Fall 2015 IUPUI, Team 1-2, Harley Fall 2015人のメンバー

IUPUI-HARLEY-F15S1G2

4 メンバー

20のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 384