Sony Handycam DCR-SR68 LCD Screen Replacement

はじめに

Can't view your pictures anymore after dropping your camera, and breaking the screen ? This guide will help you replace your LCD screen, so you can enjoy your camera once again.

必要な工具と部品

手順1 HDD

Sony Handycam DCR-SR68 LCD Screen Replacement, HDD: 手順 1、 1の画像 1

この手順で使用する道具：

Anti-Static Wrist Strap

$7.95

購入する

Wash and dry your hands, then put on a properly grounded anti-static wrist strap, before handling internal electronic components. To ground the wrist strap, attach it to the metal chassis of a plugged-in three prong power supply, of a computer for example.
Unfasten the hand strap.
Remove the battery.

翻訳

手順2

Place device on left side with front lens facing right.
Using a JIS size #00 precision Phillips screwdriver, unscrew the left middle 3mm Phillips screw.
Open the "DC IN" plastic tab (Second 3mm Phillips screw is revealed).
Unscrew the second 3mm Phillips screw.

翻訳

手順3

Turn device over onto its top with the front lens facing right.
Unscrew the top left and top right 3mm Philips screws.
The right side case panel is now unfastened (the case panel facing up in the photo).

翻訳

手順4

Remove the right side case panel by pulling up.
The Hard Drive (HDD) is now revealed.

翻訳

手順5

Sony Handycam DCR-SR68 LCD Screen Replacement: 手順 5、 3の画像 3

Using your fingers, lift the HDD from its right end, pivoting on its left end.
The HDD ribbon wire is now exposed.

翻訳

手順6

While securely holding the HDD in your left hand, use the soft pad of your right hand fingers to gently pull the ribbon wire out of its socket, toward your right.
The HDD is now free from the device.
Replace HDD.

翻訳

手順7 LCD Screen

Sony Handycam DCR-SR68 LCD Screen Replacement, LCD Screen: 手順 7、 1の画像 1

Follow steps steps 1-6 on HDD removal.
Once completed set aside HDD.

翻訳

手順8

Remove the A/V tab

翻訳

手順9

Remove the right and middle bottom 3mm Philips screws from the bottom of the device.
Then remove panel.

翻訳

手順10

On the left side of the device, remove all visible 3mm Philips screws.

翻訳

手順11

On the right side of the device, remove the two black 3mm Philips screws.
The grey tray is now loose.
Remove the grey tray by lifting out and away.

翻訳

手順12

Using the black spudger, carefully open the little black clasp on the large ribbon wire port.
These clasps are known to be fragile.
On reassembly, this wire and clasp can be troublesome to reinstall.