はじめに

This guide will detail how to detach the two halves of the phone, remove the LCD screen, and gain access to the main control buttons.

Accessing this part of the phone will allow you to clean or replace any parts that are dirty or damaged.

  1. Remove the back cover by sliding it off.
    • Remove the back cover by sliding it off.

    コメントを追加する

  2. Once the back cover is removed, pull out the battery using your finger as shown.
    • Once the back cover is removed, pull out the battery using your finger as shown.

    コメントを追加する

    • The battery can now be replaced if desired.

      • The battery is a 780 mAh rechargeable Lithium Ion battery.

    コメントを追加する

    • Remove the four 6mm phillips head screws located beneath the battery.

      • Set aside the screws in a designated container so that they can easily be found during reassembly.

    コメントを追加する

    • Remove microphone cover using a plastic opening tool.

    コメントを追加する

    • Remove the two 6mm screws on the front of the phone beneath the microphone cover.

    コメントを追加する

    • Remove the black plastic piece on the side.

    • This will allow for easier access while prying.

    コメントを追加する

    • Use the plastic prying tool to loosen the motherboard from the phone.

    コメントを追加する

    • Lift the motherboard out with your fingers once it is loose.

      • Pull slowly. This will require some force.

    コメントを追加する

    • Remove the two cable connectors using a plastic opening tool.

      • Mark the orientation and port of each cable before detaching them. The connectors are symmetrical, so this is essential for reassembly.

    • Place the motherboard aside in a safe location.

    コメントを追加する

    • On the rotational assembly.

      • Unscrew the four 3mm screws

      • Unscrew the two 2.3mm screws

    • Remember to keep the screws grouped away from the other screws in the device.

    • Lift this assembly off of the phone to allow access to the other half of the device.

    コメントを追加する

    • Detach the cable connectors on the other end of the cables using a plastic opening tool.

      • Remember to record the orientation and location of each connector.

    コメントを追加する

    • Remove the plastic cover on the back of the phone using a plastic opening tool.

    • Remove the two 6mm screws beneath this cover.

    • Also remove the two 6mm screws near the top of the phone.

    コメントを追加する

    • Pry away the screen assembly from the main case using a plastic opening tool.

    コメントを追加する

    • With face plate and LCD exposed, replace the existing cracked LCD with a new LCD if desired.

    • Be sure to test and make sure the detachable connections are arranged correctly.

    コメントを追加する

    • Remove the button and pad assembly as shown.

    • If desired, these items can now be cleaned or replaced.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Alexander

メンバー登録日: 2011年10月29日

75 ポイント

4のガイドは作成済み

チーム

University of Maryland, Team 1-1, Calloway Fall 2011 University of Maryland, Team 1-1, Calloway Fall 2011人のメンバー

UMD-CALLOWAY-F11S1G1

3 メンバー

14のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 858