はじめに

This guide goes through the procedure of replacing the lens in the Sony Cybershot DSC-P52.

Open the battery compartment and remove the batteries.
  • Open the battery compartment and remove the batteries.

  • Remove all of the visible screws on the outside of the case.

  • There should be three of them that are all easily located.

コメントを追加する

Open the memory card compartment.
  • Open the memory card compartment.

  • Remove the screw next to the memory card slot.

コメントを追加する

Pull apart the front and back cover pieces carefully.
  • Pull apart the front and back cover pieces carefully.

  • The front cover should come completely free with little effort.

  • The back cover will still be attached to the circuit board.

コメントを追加する

Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
  • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

  • The circuitry will still be connected to the back case by ribbon cables.

コメントを追加する

Open the case as shown.
  • Open the case as shown.

コメントを追加する

Unclip the clip holding the ribbon cable in.
  • Unclip the clip holding the ribbon cable in.

  • Other ribbon cables might not have a clips.

コメントを追加する

Pull the ribbon cable out.
  • Pull the ribbon cable out.

コメントを追加する

Remove the two additional screws on the back of the lens.
  • Remove the two additional screws on the back of the lens.

コメントを追加する

Detach the ribbon cables and unplug the cable leading to the back of the motherboard.
  • Detach the ribbon cables and unplug the cable leading to the back of the motherboard.

コメントを追加する

Remove the motherboard and the flash from the rest of the hardware.
  • Remove the motherboard and the flash from the rest of the hardware.

コメントを追加する

Remove the screw indicated in the picture to detach the lens and the  viewfinder from the other hardware.
  • Remove the screw indicated in the picture to detach the lens and the viewfinder from the other hardware.

コメントを追加する

Remove the three screws shown to separate the lens from the viewfinder.
  • Remove the three screws shown to separate the lens from the viewfinder.

コメントを追加する

Purchase a new viewfinder.
  • Purchase a new viewfinder.

  • Repeat the previous steps in reverse order to rebuild.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Kari Johnson

メンバー登録日: 2011年01月10日

127 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 3-43, Regan Winter 2011 Cal Poly, Team 3-43, Regan Winter 2011人のメンバー

CPSU-REGAN-W11S3G43

4 メンバー

10のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 888