メインコンテンツにスキップ

Sony Cyber-Shot DSC-TX9 Flash Replacement

必要な工具と部品

  1. Sony Cyber-Shot DSC-TX9 Flash Replacement, Prerequisites Only: 手順 1、 3の画像 1 Sony Cyber-Shot DSC-TX9 Flash Replacement, Prerequisites Only: 手順 1、 3の画像 2 Sony Cyber-Shot DSC-TX9 Flash Replacement, Prerequisites Only: 手順 1、 3の画像 3
    • Use a Phillips #0 screwdriver to unscrew the six 2mm screws on the outer case of the camera.

    • If there is a battery or SD card inside remove before beginning the process.

  2. Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 2、 2の画像 1 Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 2、 2の画像 2
    • Use your hands or a Spudger to Pull off the front cover of the camera.

    • If the casing is not coming apart easily, do not force it.

  3. Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 3、 1の画像 1
    この手順で使用する道具:
    Tweezers
    $4.99
    購入する
    • Remove the protective black cover layer with your hands and set it aside.

    • The use of tweezers may be necessary if the cover is difficult to remove.

  4. Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 4、 2の画像 1 Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 4、 2の画像 2
    • The ZIF connector can be removed by flipping the small black holder into the upright position and then sliding the ribbon cable out carefully.

    • Once this has been done, use tweezers to unplug the flat topped connector for the lens’ circuit board from the motherboard.

    • DO NOT force the ribbon cables or they will rip.

    • Refer to the (ケーブルコネクタの識別と接続の外し方) page for assistance.

  5. Sony Cyber-Shot DSC-TX9 Flash Replacement, Flash: 手順 5、 3の画像 1 Sony Cyber-Shot DSC-TX9 Flash Replacement, Flash: 手順 5、 3の画像 2 Sony Cyber-Shot DSC-TX9 Flash Replacement, Flash: 手順 5、 3の画像 3
    • Remove the two screws for the metal plate on the bottom.

    • Detach the no fuse ribbon cables by sliding them out.

    • Detach the ZIF connector cables by flipping the small black holder in an upright position and then sliding the cable out carefully.

    • Remove ribbons slowly and carefully or they WILL rip.

    • Screws are of Phillips type, head size Y0 and 0.3 mm in length.

  6. Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 6、 3の画像 1 Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 6、 3の画像 2 Sony Cyber-Shot DSC-TX9 Flash Replacement: 手順 6、 3の画像 3
    この手順で使用する道具:
    Tweezers
    $4.99
    購入する
    • Carefully remove the Memory card circuit board. You will then be able to see the flash with the capacitors connected.

    • Using tweezers, carefully remove the components. They are all connected together.

    • The circuit board should come out with little force. If it does not, make sure all connections are disconnected.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

4人の作成者と共同で作成されました。

Yegor Shea

メンバー登録日: 03/26/17

301 ポイント

3のガイドは作成済み

チーム

UMass Dartmouth, Team S4-G3, Julie Spring 2017 UMass Dartmouth, Team S4-G3, Julie Spring 2017人のメンバー

UMASSD-JULIE-S17S4G3

5 メンバー

8のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 7

今までの合計 317