メインコンテンツにスキップ

はじめに

The Sony Clie PEG-UX50 has a separate tilt screen display. This guide will show you how to remove the tilt screen without dismantling the battery plate.

パーツ

パーツは指定されていません。

  1. Take off the screws located on the two sides of the tilt screen. Unscrew the screw located at the tilt base of the screen. Unscrew the screw located at the tilt base of the screen.
    • Take off the screws located on the two sides of the tilt screen.

    • Unscrew the screw located at the tilt base of the screen.

  2. Gently remove the back plate of the tilt screen by sliding it upward. With caution, lift the wires from the track in the back plate. With caution, lift the wires from the track in the back plate.
    • Gently remove the back plate of the tilt screen by sliding it upward.

    • With caution, lift the wires from the track in the back plate.

  3. Disconnect the thin USB cable attached to the Integrated Circuit. Disconnect the thin USB cable attached to the Integrated Circuit.
    • Disconnect the thin USB cable attached to the Integrated Circuit.

  4. Detach the plastic black frame from in between the plate and the LCD. Do not disconnect the display from the board yet.
    • Detach the plastic black frame from in between the plate and the LCD.

    • Do not disconnect the display from the board yet.

  5. Disconnect the thin connector from the face plate using tweezers.
    • Disconnect the thin connector from the face plate using tweezers.

  6. Quickly release and disconnect the thick cable with your hands.
    • Quickly release and disconnect the thick cable with your hands.

終わりに

Follow these instructions in reverse order to reassemble your device.

Rishad R Rai

メンバー登録日: 2011年04月28日

1 ポイント

1ガイドが承認済み

チーム

CSU Los Angeles, Team 1-4, Nelson Spring 2011 CSU Los Angeles, Team 1-4, Nelson Spring 2011人のメンバー

CSULA-NELSON-S11S1G4

5 メンバー

2のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 1

過去 7 日: 4

過去 30 日: 4

今までの合計 2,463