はじめに

If your buttons keep getting stuck on your Blu-Ray Player, you will see in this guide that there are only a few screws to remove to easily get to the front panel.

  1. Remove the 12mm screws with the Philips #2 screwdriver which keep the plastic panels in place.
    • Remove the 12mm screws with the Philips #2 screwdriver which keep the plastic panels in place.

    • Don't forget, there are two more 12mm screws on the other side as well.

    コメントを追加する

  2. First, remove the three 12mm black screws holding the top panel on (Phillips #2).
    • First, remove the three 12mm black screws holding the top panel on (Phillips #2).

    • Then, remove the two 12mm black screws - one on each side of the back of the device - holding the top panel on.

    • Lastly, remove the three 12mm black screws on each side of device.

    コメントを追加する

    • Carefully lift up the top panel, because there are two blue ribbon cables that must be disconnected before removing the panel, and we do NOT want them to break.

    • After gently disconnecting the two ribbon cables (you can just pull them out with your hand), take the top off and set it to the side.

    コメントを追加する

    • After the top is off, you'll see that there are two metal bars that go across the top of the device.

    • Remove each bar by unscrewing the two 10mm silver screws on each end.

    コメントを追加する

    • Now, on the front panel, you will want to remove the two 10mm screws on top of the device.

    コメントを追加する

    • Place your blu-ray player so that it's facing the ceiling and support it with your non-dominant hand.

    • With your screwing hand, use the plastic opening tool to gently undo the three clips on the bottom of the device.

    • Then put the device back down and undo the two clips on the side.

    コメントを追加する

    • On the top of the panel, use the plastic opening tool to unhook the top two clips.

    • Now the front should be detached so you can remove the front panel from the rest of the device.

    コメントを追加する

    • Remove the ribbon cable found on the front panel by gently pulling at the base of the cable at each end.

    • NOTE: In these photos, the disk drive is removed. You don't have to remove the disk drive during this particular guide.

    コメントを追加する

    • Finally, remove the two 10mm screws on the front.

    • Congratulations! You have taken out the front panel!

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Mac

メンバー登録日: 2014年01月26日

107 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 9-30, Maness Winter 2014 Cal Poly, Team 9-30, Maness Winter 2014人のメンバー

CPSU-MANESS-W14S9G30

3 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 324