はじめに

Snowboard bindings are easy to take apart and replace. In this guide we will show you how to replace a Union Force binding. Most snowboard bindings are very similar to remove, but there may be some slight differences.

パーツ

パーツは必要ありません。

Release the binding straps by lifting up on the buckle and pulling towards the direction of the end of the ladder. Not all binding straps will release the same way. If you are having trouble releasing your binding straps, please refer to your owner's manual. Not all binding straps will release the same way. If you are having trouble releasing your binding straps, please refer to your owner's manual.
  • Release the binding straps by lifting up on the buckle and pulling towards the direction of the end of the ladder.

    • Not all binding straps will release the same way. If you are having trouble releasing your binding straps, please refer to your owner's manual.

コメントを追加する

Move the straps and the highback plate out of the way in order to have clear access to the foot pad screw. The highback plate is the vertical support plate located on the heel side of the binding.
  • Move the straps and the highback plate out of the way in order to have clear access to the foot pad screw.

  • The highback plate is the vertical support plate located on the heel side of the binding.

コメントを追加する

Use a #2 Phillips screwdriver to remove the panhead, 10mm wide, M4 x 12mm screw located in the middle of the foot pad. Use a #2 Phillips screwdriver to remove the panhead, 10mm wide, M4 x 12mm screw located in the middle of the foot pad.
  • Use a #2 Phillips screwdriver to remove the panhead, 10mm wide, M4 x 12mm screw located in the middle of the foot pad.

コメントを追加する

Use a #2 Phillips screwdriver to remove the four ovalhead M6 x 12mm screws that attach the base plate of the binding to the board. Lift or slide the binding off the board and set the screws aside. Lift or slide the binding off the board and set the screws aside.
  • Use a #2 Phillips screwdriver to remove the four ovalhead M6 x 12mm screws that attach the base plate of the binding to the board.

  • Lift or slide the binding off the board and set the screws aside.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Loren Sunding

メンバー登録日: 2014年01月14日

110 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 17-4, Forte Winter 2014 Cal Poly, Team 17-4, Forte Winter 2014人のメンバー

CPSU-FORTE-W14S17G4

5 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 6

過去 30 日: 38

今までの合計 3,052