メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

はじめに

Many vacuum cleaners have a separate pet hair and power brush head. The roller brush of the head can easily break due to wear and tear. Use this guide to replace the internal roller brush in the power brush head of your Shark vacuum cleaner.

  1. This Shark model brush head consists of 7 parts: a base frame, a gear, a roller brush, two side screws, a plastic round band, and a top frame of the head. Push the grey button on the back panel to open up the brush head.
    • This Shark model brush head consists of 7 parts: a base frame, a gear, a roller brush, two side screws, a plastic round band, and a top frame of the head.

    • Push the grey button on the back panel to open up the brush head.

  2. Take the purple gear out of the brush head body. Take the purple gear out of the brush head body.
    • Take the purple gear out of the brush head body.

  3. The Essential Toolkit

    コンパクト版iFixitキットの中で最も利便性の高いツール

    ショップを見る

    The Essential Toolkit

    コンパクト版iFixitキットの中で最も利便性の高いツール

    ショップを見る
  4. Pull out the roller brush from the brush head. Take out the black plastic band.
    • Pull out the roller brush from the brush head.

    • Take out the black plastic band.

    • The black band is an important component and will be needed for reassembly so keep it carefully.

  5. Pull out the side screws from the right and left side of the roller brush.
    • Pull out the side screws from the right and left side of the roller brush.

    • There are two screws, one on each side.

  6. Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush  until they are secure. Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush  until they are secure. Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush  until they are secure.
    • Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush until they are secure.

終わりに

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Roshni Sachar

メンバー登録日: 2016年03月19日

184 ポイント

1ガイドが承認済み

チーム

Michigan Tech, Team 1-23, Lauer Spring 2016 Michigan Tech, Team 1-23, Lauer Spring 2016人のメンバー

MTU-LAUER-S16S1G23

1 メンバー

1のガイドは作成済み

5 件のコメント

Cat hair will jam up in the small gap between the gear and the bushing on the turbine and will cause enough friction to stop the turbine. I used a needle to dig out the hair and it solved the problem.

hvabrams - 返信

very clear and concise. took me 5 minutes with your instructions - couldn’t find anything like this on the shark site.

tigersfoot - 返信

I need to put back all parts , don’t know where to start, can u explain step by step how to put them back please . Thank you

paolodigiacomo23 - 返信

Where can I purchase one of the side screw/fittings?

Renee Mills - 返信

Thank you to the first person who commented on the cat hair. I also took a needle to the area suggested , “It works”!

Vivienne Forsythe - 返信

コメントを追加

統計データを表示:

過去 24時間: 38

過去 7 日: 205

過去 30 日: 938

今までの合計 24,165