修理を始めるには コミュニティ ストア

Shark Navigator Motherboard Replacement

必要な工具と部品

  1. Shark Navigator Motherboard Replacement, Roller Brush Compartment: 手順 1、 1の画像 1

    • Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.

    翻訳

  2. Shark Navigator Motherboard Replacement: 手順 2、 2の画像 1 Shark Navigator Motherboard Replacement: 手順 2、 2の画像 2

    • Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.)

    • The screws have varying lengths, so keep track of where each one goes for reassembly.

    翻訳

  4. Shark Navigator Motherboard Replacement: 手順 3、 1の画像 1

    • Remove the white plastic cover to expose the roller compartment underneath.

    翻訳

  5. Shark Navigator Motherboard Replacement, Motherboard: 手順 4、 1の画像 1

    • There is one screw at the edge of the circuit board. Unscrew the circuit board before attempting to take it out.

    翻訳

  6. Shark Navigator Motherboard Replacement: 手順 5、 1の画像 1

    • Take out the circuit board and replace with a new one. It may be better to allow a professional to re-wire the circuit board to the vacuum.

    翻訳
終わりに

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

作成者

3人の作成者と共同で作成されました。

Mara

メンバー登録日: 03/27/15

469 ポイント

2のガイドは作成済み

バッジ: 9

+6 個以上のバッジ

チーム

UMass Dartmouth, Team 5-4, Kish Spring 2015 UMass Dartmouth, Team 5-4, Kish Spring 2015人のメンバー

UMASSD-KISH-S15S5G4

4 メンバー

16のガイドは作成済み

8 件のコメント

Hi ..well done with the instructions.However I do have a Shark rotator vacuum NV501 .Unfortunately the motor on the brush is not working ,so I assume the motor is burnt.My request where could I find a replacement of the motor.I have searched a lot sites online but could not find a place to rebuild nor stock the same motor.Any help would be appreciated.Thank you.....To forward any information please do so on my email jacob.brown at hotmail.com thank you....

jacob - 返信

I couldn't figure out how to remove the bottom plate, your guide helped by informing me the last two screws are located under the little wheels. Thank you!

dylananon - 返信

When I had mine apart, two black rectangle magnet fell out, I can't figure out where the came from.

mardit - 返信

I had the same problem with the magnets - where do they go>

bjolivares1055 -

Also having problem locating both mother board and brush roller motor. Where can i purchase them?

Liz - 返信

コメントを追加

統計データ:

過去 24時間: 2

過去 7 日: 8

過去 30 日: 32

今までの合計 7,703