Shark Apex DuoClean Powered Lift-Away AZ1002 Brush Roll Replacement

はじめに

If your Shark Apex DuoClean Powered Lift-Away (Model-AZ1002) brush roll is not self-cleaning, then follow the steps of this repair guide. This self-cleaning brush roll is a mechanism that automatically removes tangled hair, debris, and pet fur to ensure optimal performance and prevent clogs for uninterrupted cleaning sessions. The brush roll not cleaning may be due to excessive hair wrapped around the brush, needing to be cleared, or filters could be full. If the brush roll itself is broken, you can follow this guide to replace it.

必要な工具と部品

手順1 Brush Roll

Shark Apex DuoClean Powered Lift-Away AZ1002 Brush Roll Replacement, Brush Roll: 手順 1、 3の画像 1

Shark Apex DuoClean Powered Lift-Away AZ1002 Brush Roll Replacement, Brush Roll: 手順 1、 3の画像 2

Shark Apex DuoClean Powered Lift-Away AZ1002 Brush Roll Replacement, Brush Roll: 手順 1、 3の画像 3

Initial disassembly isn't strictly necessary, but makes accessing the brush roll simpler.
Press the hose release button while pulling to ensure the hose is unattached.
Push the release button on top of the body and lift upwards to remove. Then set aside.

編集

手順2

Shark Apex DuoClean Powered Lift-Away AZ1002 Brush Roll Replacement: 手順 2、 3の画像 3

Push the wand release and lift wand away.
Flip over the floor nozzle (the remaining piece).
Clear out any tangled hair, debris, or trash.
If necessary scissors may be used to cut it out.

編集

手順3

Pull the release buttons on each side of the floor nozzle to pop off the garage door.

編集

手順4

Turn the floor nozzle on its side where the large wheels are on your right.
Use a spudger to remove the two plastic covers to reveal the screws beneath.

編集

手順5

Remove the two Torx screws.

編集

手順6

Use a spudger to pop off the side cover.
You may have to use force and pull.

編集

手順7

Remove the two Phillips screws on either side of the brush roll.

編集

手順8

Shark Apex DuoClean Powered Lift-Away AZ1002 Brush Roll Replacement: 手順 8、 3の画像 3

Use pliers to grab the belt just below the wheel.
Pull in a circular motion around the wheel until the belt comes loose and you are able to remove it.

編集

手順9

Push the brush roll up so it pops out of its slot.
Grab the end of the brush roll and pull it completely out.

編集

手順10

Insert new brush roll until it clicks in place.
Be sure to align the brush roll end before pushing it fully in, so that it looks like the second photo. This will allow it to click into place.

編集