Shark Apex DuoClean Powered Lift Away AZ1002 Foam and Felt Filters Replacement

はじめに

Continued use of the Shark Apex DuoClean Powered Lift-Away (Model-AZ1002) can lead to loss of suction.If your vaccum is experiencing an issue with picking up debri , follow the steps of this guide to clean and/or replace the filter.

手順1 Foam and Felt Filters

Shark Apex DuoClean Powered Lift Away AZ1002 Foam and Felt Filters Replacement, Foam and Felt Filters: 手順 1、 2の画像 1

Shark Apex DuoClean Powered Lift Away AZ1002 Foam and Felt Filters Replacement, Foam and Felt Filters: 手順 1、 2の画像 2

Press the dust cup release button.

編集

手順2

Use the handle to pull the dust cup away from the wand, then lift upwards to fully free the cup.

編集

手順3

Shark Apex DuoClean Powered Lift Away AZ1002 Foam and Felt Filters Replacement: 手順 3、 3の画像 3

Pull the filter tab up to remove the large white foam filter and circular thin form at the bottom.

編集

手順4

Remove the white foam filter.
Go to a trash bin and shake both filters to remove loose dirt carefully debris.

編集

手順5

Rinse the filters thoroughly under lukewarm water until the water runs completely clear.
Avoid using hot water, as it can damage the filters.

編集

手順6

Allow the filters to air dry completely before reinserting them in the vacuum.
If the filters are not left to completely dry before replacing them in the vacuum, lingering water can cause the filters to mold.

編集