はじめに

Disassembly instructions to get at the hard drive of a Seagate FreeAgent 880GB drive

パーツ

パーツは必要ありません。

This guide holds true for most all FreeAgentGo drives that have this body style
  • This guide holds true for most all FreeAgentGo drives that have this body style

コメントを追加する

The first thing you'll need to do is get a spudger of some sort and get underneath an edge. It doesn't expressly matter which, I found starting at the front corner the the easiest.
  • The first thing you'll need to do is get a spudger of some sort and get underneath an edge. It doesn't expressly matter which, I found starting at the front corner the the easiest.

  • Work your way all the way around the edges, the cover is being held in place by rubber cement-like glue.

コメントを追加する

As you can see here, the back edge where the light is has a small connector to the rest of the board. this pulls out easily.
  • As you can see here, the back edge where the light is has a small connector to the rest of the board. this pulls out easily.

コメントを追加する

The bottom casing lets the drive fall out and you have two metal shielding pieces holding the drive in place with four rubber bumpers. The USB dongle is held in place with tape, but it's easily pulled up and removed from the plug.
  • The bottom casing lets the drive fall out and you have two metal shielding pieces holding the drive in place with four rubber bumpers. The USB dongle is held in place with tape, but it's easily pulled up and removed from the plug.

コメントを追加する

After the USB dongle is removed, there are four phillips screws on the sides that hold the two metal pieces in place. Once those are removed, the rubber bumpers are easily removed as they are only held in place by the cement as well.
  • After the USB dongle is removed, there are four phillips screws on the sides that hold the two metal pieces in place. Once those are removed, the rubber bumpers are easily removed as they are only held in place by the cement as well.

コメントを追加する

The top cover slides backwards, away from the board to allow access to the 888GB drive. The drive pulls out from here and easily disconnects from the controller board.
  • The top cover slides backwards, away from the board to allow access to the 888GB drive. The drive pulls out from here and easily disconnects from the controller board.

decent teardown. Just a suggestion, use natral lightning from the sun. The camera's flash doesn't help when your that close.

Nicholas Ouimet - 返信

Very good teardown. It would be good to know if it is a ATA drive or SATA type in case anyone needs to replace it.

alan - 返信

まとめ

To reassemble your device, follow these instructions in reverse order.

6 の人々がこのガイドを完成させました。

zenmastr

メンバー登録日: 2009年11月05日

335 ポイント

1ガイドが承認済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 20

過去 30 日: 96

今までの合計 30,812