はじめに

With this guide you will learn how to replace faulty battery spring contacts that may have been disconnected from motherboard or corroded by and exploding battery.

  1. Remove the battery compartment cover.
    • Remove the battery compartment cover.

    • Remove the battery.

    コメントを追加する

  2. Locate and remove the screw next to the battery compartment lid.
    • Locate and remove the screw next to the battery compartment lid.

    コメントを追加する

    • Locate the interlocking pegs along the seam of the device's casings.

    • Gently pry the pegs apart one at a time, working your way around the case.

    • Be careful when prying apart the pegs: they are made of plastic and may break.

    コメントを追加する

    • The battery contact springs may prevent the case from separating.

    • Push the battery contact springs down through the hole in the case.

    コメントを追加する

    • The casing protecting the USB and headphone jacks must be removed.

    • Locate and gently pry apart the two interlocking clips holding it in place.

    • The outer casings may now be removed and the MP3 player should separate.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • You now have access to all components found on the inside of the device!

    コメントを追加する

    • Locate both battery spring contacts, if necessary, on the motherboard.

    コメントを追加する

    • Apply heated soldering iron to points where the contacts are soldered to the motherboard.

    コメントを追加する

    • Soldering irons, when heated, are very hot and can potentially burn the user.

    • Be sure to always elevate the hot end of the soldering iron on a metal stand to prevent incidental burns.

    コメントを追加する

    • With solder melted, remove battery spring contacts from the motherboard.

    コメントを追加する

    • Replace spring contacts with new ones.

    コメントを追加する

    • There may be some solder in the way of the spring contacts' metal contacts. If this occurs simply melt the solder to create room for the contacts.

    コメントを追加する

    • With the new battery spring contacts in place, use the soldering iron to apply new solder to the connection points.

    • Be sure to allow the new solder to cool and harden.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

James Thorne

メンバー登録日: 2013年11月05日

625 ポイント

6のガイドは作成済み

チーム

UMass Dartmouth, Team 1-8, Shastany Fall 2013 UMass Dartmouth, Team 1-8, Shastany Fall 2013人のメンバー

UMASSD-SHASTANY-F13S1G8

3 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 5

今までの合計 369