メインコンテンツにスキップ

Samsung Stratosphere Motherboard Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. Samsung Stratosphere Motherboard Replacement, Battery: 手順 1、 1の画像 1
    • Using your fingers, pry along the groove at the top of the phone.

    • Pull back on the rear casing until it comes free from the device.

    • The casing will make a cracking sound as it is removed.

  2. Samsung Stratosphere Motherboard Replacement: 手順 2、 1の画像 1
    • With your fingers, pry from the bottom of the battery to loosen it.

    • Lift away to remove the battery from the phone.

  3. Samsung Stratosphere Motherboard Replacement, Motherboard: 手順 3、 1の画像 1
    • Locate the red and white sim card located above the battery housing.

    • Remove the sim card by sliding it downwards from its slot with your fingers.

  4. Samsung Stratosphere Motherboard Replacement: 手順 4、 1の画像 1
    • Remove the seven silver 3mm screws securing the rear panel using the Phillips #000 screwdriver.

    • Once loosened, some screws may get stuck in the casing. Use tweezers to remove them.

  5. Samsung Stratosphere Motherboard Replacement: 手順 5、 1の画像 1
    • Pry around the rear panel with a plastic opening tool to loosen it.

    • Prying too deeply may damage delicate components inside the phone.

    • Remove the rear panel from the phone with your fingers.

  6. Samsung Stratosphere Motherboard Replacement: 手順 6、 1の画像 1
    • Remove the four black 3mm screws securing the motherboard with the Phillips #000 screwdriver.

  7. Samsung Stratosphere Motherboard Replacement: 手順 7、 2の画像 1 Samsung Stratosphere Motherboard Replacement: 手順 7、 2の画像 2
    • Locate the flex cable attachment at the tab with a green arrow printed on top.

    • Pry from the side the arrow is pointing with your fingers.

    • The cable will audibly snap as it is removed from its attachment.

    • Let the cable hang loosely to the side of the phone.

  8. Samsung Stratosphere Motherboard Replacement: 手順 8、 1の画像 1
    • Pull the motherboard up from the side opposite the loose flex cable.

    • If necessary, use a plastic opening tool to separate the motherboard from the key pad underneath.

    • Lift to remove the motherboard from the device.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

5人の作成者と共同で作成されました。

Angelica Macrohon

メンバー登録日: 10/16/13

267 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 11-32, Amido Fall 2013 Cal Poly, Team 11-32, Amido Fall 2013人のメンバー

CPSU-AMIDO-F13S11G32

4 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 51