はじめに

The keypad may become broken over time, this guide will assist in the replacement of the keypad.

パーツ

パーツは必要ありません。

  1. Slide the latch on the back of the phone up.
    • Slide the latch on the back of the phone up.

  2. Remove the battery.
    • Remove the battery.

  3. After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.
    • After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.

  4. Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.
    • Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.

  5. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  6. With a #0 Phillips screwdriver remove the screw which you just uncovered.
    • With a #0 Phillips screwdriver remove the screw which you just uncovered.

  7. Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open. Then disconnect the small power connector near the top of the phone.
    • Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open.

    • Then disconnect the small power connector near the top of the phone.

  8. Gently pry up the ribbon-type connector with the spudger.
    • Gently pry up the ribbon-type connector with the spudger.

  9. Carefully pry the logic board from the case with the spudger.
    • Carefully pry the logic board from the case with the spudger.

  10. Once the logic board has been removed, peel the keypad up.
    • Once the logic board has been removed, peel the keypad up.

  11. When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing. When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.
    • When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.

まとめ

To reassemble your device, follow these instructions in reverse order.

Nathan Brink

メンバー登録日: 2010年04月11日

1 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 34-59, Forte Spring 2010 Cal Poly, Team 34-59, Forte Spring 2010人のメンバー

CPSU-FORTE-S10S34G59

4 メンバー

14のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 1,537