メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

はじめに

Use this guide to remove and replace a dysfunctional lens on the Samsung PL20 digital camera.

  1. Remove the battery and the memory card from the device. Remove the two screws on the side of the device, to the left of the camera lens. Remove the two screws on the side of the device, to the left of the camera lens.
    • Remove the battery and the memory card from the device.

    • Remove the two screws on the side of the device, to the left of the camera lens.

  2. Remove the single screw from the bottom of the device. Remove the two screws on the side of the the device, to the right of the camera lens. Using a plastic opening tool, pry the outside casing apart. Start  from the battery compartment and work around the seem of the casing.
    • Remove the single screw from the bottom of the device.

    • Remove the two screws on the side of the the device, to the right of the camera lens.

    • Using a plastic opening tool, pry the outside casing apart. Start from the battery compartment and work around the seem of the casing.

  3. Nintendo Switch 修理キット

    ゲームを再開するための、早くて簡単な修理キット

    Switch 修理キットページへ

    Nintendo Switch 修理キット

    ゲームを再開するための、早くて簡単な修理キット

    Switch 修理キットページへ
  4. Remove the back panel, revealing the LCD screen. Pull the LCD screen out of its holder. Once you have access to the connecting strip, flip the clip upwards releasing the screen completely and remove. Pull the LCD screen out of its holder. Once you have access to the connecting strip, flip the clip upwards releasing the screen completely and remove.
    • Remove the back panel, revealing the LCD screen.

    • Pull the LCD screen out of its holder. Once you have access to the connecting strip, flip the clip upwards releasing the screen completely and remove.

  5. Gently pull the front panel from the device. Remove the two screws attaching the LCD  screen holder to the device. Remove the screen holder from the rest of the device.
    • Gently pull the front panel from the device.

    • Remove the two screws attaching the LCD screen holder to the device.

    • Remove the screen holder from the rest of the device.

  6. Flip the grey clip upwards, releasing the connector from the device. Disconnect the ribbon cable extending from the left side. Disconnect the ribbon cable extending from the button bar.
    • Flip the grey clip upwards, releasing the connector from the device.

    • Disconnect the ribbon cable extending from the left side.

    • Disconnect the ribbon cable extending from the button bar.

    • Remove the 2 screws.

  7. Remove these 3 screws. releasing the lens from the logic board. Remove the lens from the logic board. Remove the lens from the logic board.
    • Remove these 3 screws. releasing the lens from the logic board.

    • Remove the lens from the logic board.

終わりに

To reassemble your device, follow these instructions in reverse order.

oldturkey03

メンバー登録日: 2010年09月29日

649,536 ポイント

103のガイドは作成済み

コメント1件

Beware there is a capacitor that stores a charge even when the battery is removed. On my camera i touched it, it created a short circuit, i got a shock, and it killed my camera.

morrisettema - 返信

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 6

今までの合計 2,580