はじめに

This guide will show you how to replace your microphone.

  1. Slide your fingernail into the slit at the bottom of the phone to remove the back cover.
    • Slide your fingernail into the slit at the bottom of the phone to remove the back cover.

    コメントを追加する

  2. Place your finger in either of the bottom corner of the battery slot and lift to remove the battery.
    • Place your finger in either of the bottom corner of the battery slot and lift to remove the battery.

    コメントを追加する

    • Remove six 5 mm Phillips #0 screws from the back of the phone.

    コメントを追加する

    • Insert a plastic opening tool into the seam between the back case and the rest of the phone.

    • Working along the seam, pry the back from the phone.

    コメントを追加する

    • Remove the two remaining 3.75 mm Phillips screws.

    コメントを追加する

    • Firmly grip the black lever with tweezers

    • Use the tweezers to flip the black lever up so that it is perpendicular to the motherboard.

    コメントを追加する

    • Carefully use the tweezers to slide the black ZIF cable out of the socket.

    コメントを追加する

    • Use the tweezers to unclip the black connector as shown.

    コメントを追加する

    • Use the tweezers to unclip the orange flexible circuit board from the side of the phone.

    コメントを追加する

    • Use the tweezers to unclip the other orange, smaller flexible circuit board.

    • Work carefully. This is a very delicate part of the phone that can easily be broken.

    コメントを追加する

    • Slide one side of the tweezers underneath the red and blue wires of the capacitor.

    • Carefully apply pressure away from the phone to lift.

    コメントを追加する

    • Carefully tilt the motherboard up from the back of the phone.

    • Don't remove the motherboard completely. There is one more clip on the backside of the motherboard that needs to be removed.

    • Use tweezers to unclip the black connector.

    コメントを追加する

    • Hold the phone by the black plastic at the ends and slightly bend them down so that the middle of the phone is the highest point. Apply pressure slowly until the until the grey portion pops off.

    コメントを追加する

    • Insert the tweezers into the hole as shown so that they are wedged between the LCD and grey plastic.

    • Slide the tweezers underneath the LCD, around the three silver edges, until the entire display is lifted from grey plastic.

    コメントを追加する

    • Find the rubber microphone backing on the bottom of the back of the front cover as shown in the picture. Use tweezers to pluck the microphone from the casing.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Collin Gordon

メンバー登録日: 2013年04月08日

45 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 17-1, Regan Spring 2013 Cal Poly, Team 17-1, Regan Spring 2013人のメンバー

CPSU-REGAN-S13S17G1

4 メンバー

18のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 183