はじめに

If camera lens jams or breaks, this guide will help you replace it.

Remove the six external screws from the camera using a Phillips #0 screwdriver.
  • Remove the six external screws from the camera using a Phillips #0 screwdriver.

  • After the screws has been removed, the bottom of the back half of the external case should be loosened from the camera.

  • Be careful, make sure you don't lose the screws.

コメントを追加する

Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.
  • Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.

コメントを追加する

  • Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera.

コメントを追加する

  • Carefully squeeze the top right corner of the camera and pry off the external cover.

  • If you hear a "cracking" sound. This is normal.

  • Continue to pull the external cover and it will come off cleanly.

  • Be cautious of the flash capacitor. It carries an electrical charge, that may give you an unpleasant shock.

コメントを追加する

  • Carefully pull off the back cover, parts behind the back of the case might fall out.

コメントを追加する

  • Remove the front cover, it comes off easily.

  • Buttons might fall out when you remove the front cover.

コメントを追加する

  • Remove green tape from ribbon.

コメントを追加する

  • Remove four screws around lens.

コメントを追加する

  • Use spudger to remove ribbon connecting the circuit board from lens.

コメントを追加する

  • Remove lens from camera.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

Adriel

メンバー登録日: 2010年04月15日

120 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 6-17, Maness Spring 2010 Cal Poly, Team 6-17, Maness Spring 2010人のメンバー

CPSU-MANESS-S10S6G17

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 11

今までの合計 8,970