Skip to main content

ガイド紹介

A camera installed in a phone is susceptible to damage if the phone is dropped and lands on the area where the camera is located. This guide highlights how to remove the back cover of the tablet in order to get to the camera as a means to replace it.

  1. Make sure the device is turned off before attempting to disassemble it.
    • Make sure the device is turned off before attempting to disassemble it.

    • At the top portion of the memory card slot, use the small metal spudger to create separation between the back cover and the rest of the device.

    • The small metal spudger is only used to create separation between the back cover and the rest of the device, not to remove the back cover.

  2. Use the intermediate metal spudger in place of the small metal spudger to remove the back cover. This is done by sliding the intermediate metal spudger around the perimeter of the device, beginning at the top portion of the memory card slot. The second picture shows the internal portion of the device once the back cover is removed.
    • Use the intermediate metal spudger in place of the small metal spudger to remove the back cover. This is done by sliding the intermediate metal spudger around the perimeter of the device, beginning at the top portion of the memory card slot.

    • The second picture shows the internal portion of the device once the back cover is removed.

  3. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  4. Use the spudger to disconnect the camera from the motherboard. This step should be done at the yellow rubber portion of the camera.
    • Use the spudger to disconnect the camera from the motherboard.

    • This step should be done at the yellow rubber portion of the camera.

    • The first and second pictures show what the camera looks like when it is still connected to the motherboard and once it is disconnected, respectively.

  5. Use the spudger to remove the main body of the camera from the rest of the device. This should be done anywhere around the black-framed perimeter of the camera.
    • Use the spudger to remove the main body of the camera from the rest of the device. This should be done anywhere around the black-framed perimeter of the camera.

  6. Use the tweezers to fully remove the camera from the rest of the device. The camera should be pulled out and away from where the device was connected to the motherboard in Step 3. The second picture illustrates what the device should look like once the camera is removed. The second picture illustrates what the device should look like once the camera is removed.
    • Use the tweezers to fully remove the camera from the rest of the device. The camera should be pulled out and away from where the device was connected to the motherboard in Step 3.

    • The second picture illustrates what the device should look like once the camera is removed.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Michael Wozny

メンバー登録日: 2016年02月04日

2,823 Reputation

5のガイドは作成済み

チーム

USF Tampa, Team 17-4, Blackwell Winter 2016 USF Tampa, Team 17-4, Blackwell Winter 2016人のメンバー

USFT-BLACKWELL-W16S17G4

4 メンバー

10のガイドは作成済み

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 35

All Time: 941