はじめに

If your camera stops working or there are constant smudges or discoloration spots in your pictures, your camera lens may be broken or malfunctioning. Replace it by following these steps.

Locate the small slit on the bottom edge of the device between the back and front cases.
  • Locate the small slit on the bottom edge of the device between the back and front cases.

  • Pop the back case off by inserting your finger and pulling the case away from the phone.

コメントを追加する

Remove the battery by pushing the bottom edge of the battery up and away from the phone
  • Remove the battery by pushing the bottom edge of the battery up and away from the phone

コメントを追加する

  • Remove SIM card by pushing down and away from the slot, then pulling it out toward the bottom edge of the phone.

コメントを追加する

  • Remove the seven 4.5 mm Phillips #00 screws along the perimeter of the phone.

コメントを追加する

  • Staring near the power button, use a plastic opening tool to disengage the plastic clips securing the midframe.

    • Work carefully, and disengage all of the clips before removing the midframe.

  • The power button and the volume control button on the sides of the phone will fall out when the midframe is removed.

コメントを追加する

  • Slide the SD card out of its slot.

コメントを追加する

  • Disconnect the ribbon cable and camera lens by tugging gently at the base of the ribbon cable either by pinching with fingers or with the Tweezers.

    • Only use the pinching method when the camera lens is already broken so as to avoid damage.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Taylor Catlin

メンバー登録日: 2013年01月15日

79 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 18-37, Regan Winter 2013 Cal Poly, Team 18-37, Regan Winter 2013人のメンバー

CPSU-REGAN-W13S18G37

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 4

今までの合計 2,316