メインコンテンツにスキップ

はじめに

This general guide shows how to apply custom-cut battery adhesive for Samsung Galaxy S smartphones.

If you are using double-sided tape instead, use this guide as a general guideline for where to apply the tape.

  1. Remove any remaining adhesive from the phone frame, and clean the glued areas with isopropyl alcohol and a lint-free cloth.
    • Remove any remaining adhesive from the phone frame, and clean the glued areas with isopropyl alcohol and a lint-free cloth.

  2. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  3. Before you begin, note how the pre-cut adhesive strip should be oriented in the battery well. Peel the clear plastic liner off of the pre-cut adhesive strip, exposing the adhesive. Line up a long edge of the adhesive with the edge of the battery well.
    • Before you begin, note how the pre-cut adhesive strip should be oriented in the battery well.

    • Peel the clear plastic liner off of the pre-cut adhesive strip, exposing the adhesive.

    • Line up a long edge of the adhesive with the edge of the battery well.

    • Set the adhesive down lightly on the frame.

    • If it is not properly aligned, you can carefully peel the adhesive back up and realign it.

  4. Once the adhesive is aligned, use your fingers to press the adhesive onto the frame. When you are ready to stick the battery onto the frame, carefully peel away the blue plastic liner to expose the adhesive.
    • Once the adhesive is aligned, use your fingers to press the adhesive onto the frame.

    • When you are ready to stick the battery onto the frame, carefully peel away the blue plastic liner to expose the adhesive.

    • Set the battery lightly in place.

    • Plug in the battery connector temporarily to ensure that the cable reaches the socket. Disconnect the battery before resuming re-assembly.

    • Press the battery perimeter firmly with your fingers to help the adhesive bond.

まとめ

For optimal performance, calibrate your newly installed battery: Charge it to 100% and keep charging it for at least 2 more hours. Then use your device until it shuts off due to low battery. Finally, charge it uninterrupted to 100%.

ある他の人がこのガイドを完成しました。

Arthur Shi

メンバー登録日: 2018年01月03日

54,050 ポイント

172のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

101 メンバー

8,679のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 48

過去 7 日: 244

過去 30 日: 386

今までの合計 425