-
-
Insert an opening tool or fingernail into the tab on the power button side of the phone.
-
Lift on the tab to pry the back cover off of the phone.
-
Continue to pry off the back all around the edges of the phone until the entire cover is fully removed.
-
-
-
-
To remove the SD card and Sim card, look above the battery bay and slide the card out.
-
Insert an opening tool to lift up and the plastic plate that covers the LCD ribbon cable and remove it.
-
-
-
Use a heat gun or a heating device to lightly heat the edges of the screen on the phone
-
Insert an opening tool between the screen and plastic bezel, then apply pressure to separate.
-
You can also push the screen out in the empty slot where the battery was to separate.
-
It is important to be quick but careful when separating the screen and plastic bezel because the glue could cool down and re-bond the two parts.
-
-
Use a plastic spudger to disconnect the ribbon cable from the loudspeaker unit.
-
Lift from the top of the loudspeaker unit to release from the phone.
-
You do not need to remove the motherboard to do this.
このガイドを埋め込む
サイズを選択し、以下のコードをコピーして、このガイドを小さなウィジェットとしてサイト/フォーラムに埋め込みます。
プレビュー