メインコンテンツにスキップ

はじめに

Use this guide to replace your motherboard. When following these steps ensure that you do not remove the glass screen from the digitizer during step four.

パーツ

パーツは指定されていません。

  1. Insert a finger nail or plastic opening tool between the back cover and the device.
    • Insert a finger nail or plastic opening tool between the back cover and the device.

    • Gently pry the rear cover off of the back of the phone.

  2. Using a finger, pull the SIM card down out of its slot. Remove the SIM card.
    • Using a finger, pull the SIM card down out of its slot.

    • Remove the SIM card.

    • The pictured device is missing the SIM card and battery.

  3. Using a Phillips #00 screwdriver remove the eleven 3 mm screws.
    • Using a Phillips #00 screwdriver remove the eleven 3 mm screws.

  4. Insert a plastic opening tool between the screen and the back of the device. Starting at the bottom of the device, gently slide the tool along the edges of the screen. Gently pry the main assembly from the midframe of the device.
    • Insert a plastic opening tool between the screen and the back of the device.

    • Starting at the bottom of the device, gently slide the tool along the edges of the screen.

    • Gently pry the main assembly from the midframe of the device.

    • When removing the main assembly, pry gently so as to not crack the glass screen or break any clips within the device.

  5. Use the flat edge of a spudger to disconnect the ear speaker connector. Use the flat edge of a spudger to disconnect the ear speaker connector.
    • Use the flat edge of a spudger to disconnect the ear speaker connector.

  6. Use the flat end of a spudger disconnect the digitizer connector. Use the flat end of a spudger disconnect the digitizer connector.
    • Use the flat end of a spudger disconnect the digitizer connector.

  7. Use the flat end of a spudger disconnect the front-facing camera cable connector. Use the flat end of a spudger disconnect the front-facing camera cable connector.
    • Use the flat end of a spudger disconnect the front-facing camera cable connector.

  8. Remove the front-facing camera. Remove the front-facing camera.
    • Remove the front-facing camera.

  9. Use the flat end of a spudger to gently pry under the motherboard. Remove the motherboard. Remove the motherboard.
    • Use the flat end of a spudger to gently pry under the motherboard.

    • Remove the motherboard.

  10. Use the flat end of a spudger to disconnect the rear camera cable connector.
    • Use the flat end of a spudger to disconnect the rear camera cable connector.

  11. Remove the rear camera. Remove the rear camera.
    • Remove the rear camera.

まとめ

To reassemble your device, follow these instructions in reverse order.

14 の人々がこのガイドを完成させました。

Sean Kramer

メンバー登録日: 2018年02月14日

1,128 ポイント

6のガイドは作成済み

チーム

USF Tampa, Team S5-G4, Eyestone Spring 2018 USF Tampa, Team S5-G4, Eyestone Spring 2018人のメンバー

USFT-EYESTONE-S18S5G4

3 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 28

過去 30 日: 142

今までの合計 2,844