Begin by turn the device over to it's back, with the screen facing down.
  • Begin by turn the device over to it's back, with the screen facing down.

コメントを追加する

At the top of the device there is a small notch that is used to remove the battery door. Using a pry tool or your fingernail, pry off the battery door from the main housing.
  • At the top of the device there is a small notch that is used to remove the battery door.

  • Using a pry tool or your fingernail, pry off the battery door from the main housing.

コメントを追加する

Place the battery door to the side. Using a pry tool or your fingernail, pry the battery up towards you. You have now removed the battery!
  • Place the battery door to the side.

  • Using a pry tool or your fingernail, pry the battery up towards you.

  • You have now removed the battery!

コメントを追加する

Make sure when replacing the battery that the arrow on the bottom is facing down.
  • Make sure when replacing the battery that the arrow on the bottom is facing down.

コメントを追加する

Remove the 6 Phillips head screws that hold the rear housing in place.
  • Remove the 6 Phillips head screws that hold the rear housing in place.

コメントを追加する

Using a spudger or plastic pry tool, slowly go around the phone between the display & rear housing to release the clips.
  • Using a spudger or plastic pry tool, slowly go around the phone between the display & rear housing to release the clips.

コメントを追加する

Lift the rear housing from the display assembly.
  • Lift the rear housing from the display assembly.

コメントを追加する

Using your spudger/plastic pry tool, disconnect the headphone jack flex cable. Using your spudger/plastic pry tool, disconnect the headphone jack flex cable.
  • Using your spudger/plastic pry tool, disconnect the headphone jack flex cable.

コメントを追加する

Using your spudger/plastic pry tool, disconnect the rear speaker flex cable. Using your spudger/plastic pry tool, disconnect the rear speaker flex cable.
  • Using your spudger/plastic pry tool, disconnect the rear speaker flex cable.

コメントを追加する

Using a spudger/pry tool, carefully remove the vibration motor from its housing. This has a mild adhesive on the bottom.
  • Using a spudger/pry tool, carefully remove the vibration motor from its housing. This has a mild adhesive on the bottom.

コメントを追加する

After removing both flex cables, slowly move the logic board to the left of the screen assembly. Do not try and remove the logic board all the way, as you still have to remove the display assembly flex cable!
  • After removing both flex cables, slowly move the logic board to the left of the screen assembly.

  • Do not try and remove the logic board all the way, as you still have to remove the display assembly flex cable!

コメントを追加する

Using your spudger/plastic pry tool, disconnect the LCD/Digitizer flex cable.
  • Using your spudger/plastic pry tool, disconnect the LCD/Digitizer flex cable.

コメントを追加する

You have now removed the logic board from the display assembly. You have now removed the logic board from the display assembly.
  • You have now removed the logic board from the display assembly.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Josh Forester

メンバー登録日: 2010年11月28日

2,294 ポイント

10のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 5

今までの合計 284