メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

はじめに

Tuning keys are necessary to play a guitar. However, they can sometimes break, especially on old or used guitars. This makes playing the guitar significantly more difficult or, in some cases, impossible. If the tuning keys on your guitar are broken, this guide will help replace them. Specifically, this guide will help you repair and replace tuning keys on an SR 306-12951100 Acoustic Guitar. We will be replacing the old tuning keys with 3x3 plate tuning keys.

This guide assumes you have already removed the strings from the guitar. If you have not, follow Steps 1 and 2 from this guide for instructions.

パーツ

  1. Remove the four outer screws. Then remove the four inner screws. The screws are located on the back of the guitar head.
    • Remove the four outer screws.

    • Then remove the four inner screws.

    • The screws are located on the back of the guitar head.

  2. Slide all of the collars off of the old tuning keys. The collars are found on the tuning key pegs on the front head of the guitar.  One of the collars is indicated in the first picture.
    • Slide all of the collars off of the old tuning keys.

    • The collars are found on the tuning key pegs on the front head of the guitar. One of the collars is indicated in the first picture.

    • Some of the collars may be difficult to remove. Apply gentle pressure until they pop off.

  3. Remove the old tuning keys by sliding them out of the holes. It helps to put the guitar on its side and hold the head of the guitar from the front and push the old tuning keys out the back. It helps to put the guitar on its side and hold the head of the guitar from the front and push the old tuning keys out the back.
    • Remove the old tuning keys by sliding them out of the holes.

    • It helps to put the guitar on its side and hold the head of the guitar from the front and push the old tuning keys out the back.

  4. Clean the guitar head and tuning key holes using a microfiber cloth to ensure that the new tuning keys will fit properly. This step may require more or less effort depending on how much epoxy was used to hold the old tuning keys in place.
    • Clean the guitar head and tuning key holes using a microfiber cloth to ensure that the new tuning keys will fit properly.

    • This step may require more or less effort depending on how much epoxy was used to hold the old tuning keys in place.

  5. Insert one of the new tuning key racks into the appropriate tuning key holes. Both of the new tuning key pieces are identical, so either plate can be used. The plate should have an overall length of 102 mm.  The center to center distance between posts should be 35 mm.
    • Insert one of the new tuning key racks into the appropriate tuning key holes.

    • Both of the new tuning key pieces are identical, so either plate can be used.

    • The plate should have an overall length of 102 mm. The center to center distance between posts should be 35 mm.

  6. Insert the second tuning key rack into the appropriate tuning key holes. Insert the second tuning key rack into the appropriate tuning key holes. Insert the second tuning key rack into the appropriate tuning key holes.
    • Insert the second tuning key rack into the appropriate tuning key holes.

  7. Begin installing the four outer screws. Then install the four inner screws. The dimensions of the screws that come with the kit are 31 mm x 35 mm x 27 mm.
    • Begin installing the four outer screws.

    • Then install the four inner screws.

    • The dimensions of the screws that come with the kit are 31 mm x 35 mm x 27 mm.

    • Do not tighten the screws until all of them are in place. Once all eight screws are in, go back and tighten each one. This is done so that the new tuning keys can be properly aligned.

  8. The tuning keys are now properly installed. Install new guitar strings by following this video (start at 1 min 20 sec.) and this guide.
    • The tuning keys are now properly installed.

    • Install new guitar strings by following this video (start at 1 min 20 sec.) and this guide.

ゴール

ある他の人がこのガイドを完成しました。

Michael Biancardi

メンバー登録日: 2020年01月16日

181 ポイント

1ガイドが承認済み

チーム

University of North Texas, Team S1-G10, Raign Spring 2020 University of North Texas, Team S1-G10, Raign Spring 2020人のメンバー

UNT-RAIGN-S20S1G10

2 メンバー

1のガイドは作成済み

コメント1件

I literally just bought this exact guitar at goodwill!

Hugh Bourns - 返信

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 34

今までの合計 227