メインコンテンツにスキップ

Ryobi RJ1861V Assembly Bar Bearing Replacement

必要な工具と部品

  1. Ryobi RJ1861V Assembly Bar Bearing Replacement, Saw Bar Assembly: 手順 1、 1の画像 1
    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

  2. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 2、 2の画像 1 Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 2、 2の画像 2
    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

  3. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 3、 1の画像 1
    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

  4. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 4、 1の画像 1
    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

  5. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 5、 1の画像 1
    • Remove the backside panel.

  6. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 6、 1の画像 1
    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

  7. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 7、 1の画像 1
    • Lift the assembly bar up and out of the chassis.

  8. Ryobi RJ1861V Assembly Bar Bearing Replacement, Assembly Bar Bearing: 手順 8、 1の画像 1
    • Begin with the top of the device facing up.

  9. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 9、 1の画像 1
    • Insert needle nose pliers to remove the retaining pin at the top of the bearing.

  10. Ryobi RJ1861V Assembly Bar Bearing Replacement: 手順 10、 1の画像 1
    • Once the retaining pin has been removed, pull off the damaged bearing and insert a new one.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

作成者

3人の作成者と共同で作成されました。

Morgan Doyle

メンバー登録日: 04/08/19

316 ポイント

2のガイドは作成済み

チーム

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 5

過去 30 日: 22

今までの合計 438