メインコンテンツにスキップ

はじめに

This guide will help the user disassemble the drill, replace the broken or worn out reverse switch, and reassemble the drill.

パーツ

パーツは指定されていません。

  1. Detach the battery unit from the drill body by pressing the battery release buttons on both sides of the unit and pulling outwards. Detach the battery unit from the drill body by pressing the battery release buttons on both sides of the unit and pulling outwards. Detach the battery unit from the drill body by pressing the battery release buttons on both sides of the unit and pulling outwards.
    • Detach the battery unit from the drill body by pressing the battery release buttons on both sides of the unit and pulling outwards.

  2. Remove all ten Torx screws from the drill's case.
    • Remove all ten Torx screws from the drill's case.

  3. Gently pull the casing apart.
    • Gently pull the casing apart.

    • Separating the casing too quickly could cause internals to become loose, and not easily seat together upon reassembly.

  4. Remove the trigger so that it can fully expose the reverse switch.
    • Remove the trigger so that it can fully expose the reverse switch.

  5. Firmly grab the reverse switch and pull on it until it comes out of its socket.
    • Firmly grab the reverse switch and pull on it until it comes out of its socket.

終わりに

To reassemble your device, follow these instructions in reverse order.

nathan krehbiel

メンバー登録日: 2019年11月05日

229 ポイント

2のガイドは作成済み

チーム

UMass Dartmouth, Team S2-G6, Barthe Fall 2019 UMass Dartmouth, Team S2-G6, Barthe Fall 2019人のメンバー

UMASSD-BARTHE-F19S2G6

3 メンバー

10のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 1

過去 7 日: 4

過去 30 日: 19

今までの合計 380