はじめに

This guide will help you remove the turning gears of the Rival Mini Blender. Removing the gears will allow you to access the interior components of the device.

Twist the plastic lid counterclockwise to unlock it. Lift the lid to remove it from the container.
  • Twist the plastic lid counterclockwise to unlock it.

  • Lift the lid to remove it from the container.

コメントを追加する

Carefully remove the blade from the container.
  • Carefully remove the blade from the container.

  • For reassembly, the teeth on the metal shaft line up with slots on the inside of the plastic hole.

コメントを追加する

With your hand, twist the container counter-clockwise until it unlocks from the base. Remove the container by lifting it straight up.
  • With your hand, twist the container counter-clockwise until it unlocks from the base. Remove the container by lifting it straight up.

コメントを追加する

Use your fingers to pry out the two rubber feet from the bottom cover of the base.
  • Use your fingers to pry out the two rubber feet from the bottom cover of the base.

  • The two feet furthest from the button tower contain screws. The other two feet do not.

コメントを追加する

Use the Phillips #2 screwdriver  to unscrew the two 12.7-mm screws underneath the rubber feet. Use the same screwdriver to unscrew the 15.88-mm screw from the back of the chopper.
  • Use the Phillips #2 screwdriver to unscrew the two 12.7-mm screws underneath the rubber feet.

  • Use the same screwdriver to unscrew the 15.88-mm screw from the back of the chopper.

コメントを追加する

Firmly lift the bottom cover off of the base.
  • Firmly lift the bottom cover off of the base.

コメントを追加する

Remove the smaller white gear by lifting it up with your hand.
  • Remove the smaller white gear by lifting it up with your hand.

コメントを追加する

Use a pair of pliers or any other clamping tool to securely hold the blade-shaft that sits above the base. Grab the gear with your other hand and turn CLOCKWISE. Unlike most screws, the gear is reverse-threaded to allow the blade to spin. Continue turning the gear until completely removed from the blade-shaft.
  • Use a pair of pliers or any other clamping tool to securely hold the blade-shaft that sits above the base.

  • Grab the gear with your other hand and turn CLOCKWISE. Unlike most screws, the gear is reverse-threaded to allow the blade to spin.

  • Continue turning the gear until completely removed from the blade-shaft.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Roxanne

メンバー登録日: 2013年10月17日

507 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 4-29, Amido Fall 2013 Cal Poly, Team 4-29, Amido Fall 2013人のメンバー

CPSU-AMIDO-F13S4G29

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 4

今までの合計 336