Skip to main content

ガイド紹介

In this guide, we will show you how to replace the camera in a Ring Stick Up Cam. You will need a Phillips #00 screwdriver and a plastic opening tool.

パーツ

パーツは指定されていません。

  1. Remove the six 6mm Phillips #00 screws from the back of the device.
    • Remove the six 6mm Phillips #00 screws from the back of the device.

  2. Pry off the aluminum plate using a plastic opening tool.
    • Pry off the aluminum plate using a plastic opening tool.

  3. Remove the two 6mm Phillips #00 screws that were under the aluminum plate.
    • Remove the two 6mm Phillips #00 screws that were under the aluminum plate.

  4. Pry off the back cover using a plastic opening tool.
    • Pry off the back cover using a plastic opening tool.

  5. Disconnect the battery power leads using a plastic opening tool.
    • Disconnect the battery power leads using a plastic opening tool.

  6. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  7. Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.
    • Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.

  8. Remove the three silver  6mm Phillips #00 screws holding the motherboard in the device.
    • Remove the three silver 6mm Phillips #00 screws holding the motherboard in the device.

  9. Disconnect the ribbon connector shown in the photo.
    • Disconnect the ribbon connector shown in the photo.

  10. Remove the motherboard from the device by hand.
    • Remove the motherboard from the device by hand.

  11. Remove the two black 5mm Phillips #00 screws holding the camera board into the device.
    • Remove the two black 5mm Phillips #00 screws holding the camera board into the device.

    • Remove the single silver 10mm Phillips #00 screw holding the camera board into the device.

  12. Remove the three plastic spacers shown in the photo by hand.
    • Remove the three plastic spacers shown in the photo by hand.

  13. Carefully disconnect the camera board from the daughterboard by sliding a  plastic opening tool between the camera board and the daughterboard.
    • Carefully disconnect the camera board from the daughterboard by sliding a plastic opening tool between the camera board and the daughterboard.

  14. Lift the camera board out of the housing using your hand.
    • Lift the camera board out of the housing using your hand.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Ao Li

メンバー登録日: 2019年02月06日

245 Reputation

1ガイドが承認済み

Team

UC Davis, Team S18-G3, Lore Winter 2019 UC Davis, Team S18-G3, Lore Winter 2019人のメンバー

UCD-LORE-W19S18G3

3 メンバー

4のガイドは作成済み

One Comment

Where can I purchase a new lens?

Javier Casas - 返信

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 14

Past 30 Days: 90

All Time: 584