Ring Outdoor Security Cam Speakers Replacement

はじめに

This guide is for the purpose of demonstrating how to replace a Ring Outdoor Security Cam speaker. Like many cameras, a common issue with Ring's outdoor cam is the speaker's which overtime can become damaged resulting in warped or no audio. There are no safety hazards for this fix, and the difficulty level is moderate. It's an easy, fast fix with no specific experience or knowledge aside from screws.

必要な工具と部品

手順1 Speakers

Ring Outdoor Security Cam Speakers Replacement, Speakers: 手順 1、 1の画像 1

Remove the six 6 mm Phillips #00 screws from the back on the device.

翻訳

手順2

Pry off the aluminum plate using a plastic opening tool.

翻訳

手順3

Use an opening tool to pry the back plate off of the device.

翻訳

手順4

Disconnect the battery power leads using a plastic opening tool.

翻訳

手順5

Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.

翻訳

手順6

Disconnect the ribbon cable carefully at the bottom of the device.
Remove the 3 silver 6 mm Phillips #00 screws from the motherboard.

翻訳

手順7

Pull the top of the motherboard up and out of the device.

翻訳

手順8

Remove the silver 5vmm Phillips #00 screw, and the two 10mm Phillips #00 from the next circuit board.
Remove the 3 plastic spacers on the device.

翻訳

手順9

Ring Outdoor Security Cam Speakers Replacement: 手順 9、 3の画像 3

Pry the motherboard out with a plastic opening tool.
Flip the device over and then carefully press on the camera lens to remove the camera and the attached mother board from the device.

翻訳

手順10

Remove the six silver 4.5 mm Phillips #00 screws holding the daughterboard into the device.
Then use the plastic prying tool to remove the final daughterboard and attached microphone

翻訳