メインコンテンツにスキップ

このバージョンは誤った内容を含んでいる可能性があります。最新の承認済みスナップショットに切り替えてください。

必要な工具と部品

  1. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 1、 1の画像 1
    • Before disassembling your Atari Lynx, be sure the device is powered off.

    • Remove any game in the console by opening the right latch and sliding the game to the right.

  2. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 2、 1の画像 1
    • Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

    • Pinch the rear panel with your fingers and lift away from the Atari.

  3. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 3、 1の画像 1
    • Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear any wires attached to battery panel.

  4. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 4、 1の画像 1
    • Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear the speaker wire while removing the control panel.

  5. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 5、 1の画像 1
    • If you want to replace the buttons other than the D-pad, you can pull them up by pinching the sides with your fingers and lifting away from the front panel of Atari.

  6. この手順は未翻訳です。 翻訳を手伝う。

    : 手順 6、 2の画像 1 : 手順 6、 2の画像 2
    • To remove the D-Pad, remove three 10 mm Phillips #0 screws surrounding the D-Pad.

    • The buttons should fall out once the screws have been removed.

ゴール

作成者

4人の作成者と共同で作成されました。

Tyler Williams

メンバー登録日: 01/26/14

333 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 1-42, Maness Winter 2014 Cal Poly, Team 1-42, Maness Winter 2014人のメンバー

CPSU-MANESS-W14S1G42

5 メンバー

16のガイドは作成済み

コメント 1 件

Thanks for the guide. The title photo shows a Lynx II, however, while all the detailed instructions are for the original Lynx (I) which is built differently.

It would be great to have a Lynx II disassembly and MOSFET Q12 replacement guide.

Siegfried Lenz - 返信

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 10

過去 30 日: 18

今までの合計 2,203