メインコンテンツにスキップ

はじめに

This guide will show you how to remove or replace the motherboard on the Xiaomi Redmi Note 7 Pro. You will need some replacement adhesive to reattach the components when you reassemble the device.

  1. Before you begin, switch off your phone.
    • Before you begin, switch off your phone.

    • Heat your phone to about 195 degrees Fahrenheit (90 C).

  2. Lift the back cover to create a gap between the glass and the frame.
    • Lift the back cover to create a gap between the glass and the frame.

    • Insert an opening pick into the gap.

  3. Start sliding the opening pick from the lower left corner along the side of the device to cut the adhesive
    • Start sliding the opening pick from the lower left corner along the side of the device to cut the adhesive

    • Leave the opening pick in the side to prevent the adhesive from resealing.

  4. Lift the cover open like a book, but be careful to make sure you do not damage the flex cable while it’s still connected.
    • Lift the cover open like a book, but be careful to make sure you do not damage the flex cable while it’s still connected.

  5. Using a screwdriver (1.5 mm ), unscrew 4 screw and remove the bracket holding the connector. Using a screwdriver (1.5 mm ), unscrew 4 screw and remove the bracket holding the connector.
    • Using a screwdriver (1.5 mm ), unscrew 4 screw and remove the bracket holding the connector.

  6. Disconnect the connector to avoid a possible short circuit during disassembly.
    • Disconnect the connector to avoid a possible short circuit during disassembly.

    • Disconnect connectors and remove the inter-board cable.

  7. Using a screwdriver (1.5 mm), unscrew the 7 screws. Remove the cover. Remove the cover.
    • Using a screwdriver (1.5 mm), unscrew the 7 screws.

    • Remove the cover.

  8. Pry up on the connector and remove the fingerprint sensor cable.
    • Pry up on the connector and remove the fingerprint sensor cable.

  9. Disconnect the connector on PCB, and remove the front facing (selfie) camera.
    • Disconnect the connector on PCB, and remove the front facing (selfie) camera.

  10. Disconnect the connectors on the PCB.
    • Disconnect the connectors on the PCB.

  11. Pull off and remove the PCB.
    • Pull off and remove the PCB.

終わりに

To reassemble your device, follow these instructions in reverse order.

11 の人々がこのガイドを完成させました。

以下の翻訳者の皆さんにお礼を申し上げます:

es en

100%

これらの翻訳者の方々は世界を修理する私たちのサポートをしてくれています。 あなたも貢献してみませんか?
翻訳を始める ›

Remphone.ru

メンバー登録日: 2019年10月02日

481 ポイント

1ガイドが承認済み

コメント1件

Give Me Your Phone Number..

The Comedy King - 返信

コメントを追加

統計データを表示:

過去 24時間: 16

過去 7 日: 65

過去 30 日: 290

今までの合計 5,972