はじめに

This guide will show you how to remove the switch cover assembly from the laptop.

Flip laptop over and locate the battery release button Push release button to the left to release battery and gently pull battery from the laptop Push release button to the left to release battery and gently pull battery from the laptop
  • Flip laptop over and locate the battery release button

  • Push release button to the left to release battery and gently pull battery from the laptop

コメントを追加する

Loosen the three Phillips 2.5×9.0 captive screws that secure the keyboard to the laptop Turn the laptop so the keyboard is facing up and locate the 4 retention tabs along the back edge of the keyboard Slide the retention clips toward the keyboard to release the keyboard
  • Loosen the three Phillips 2.5×9.0 captive screws that secure the keyboard to the laptop

  • Turn the laptop so the keyboard is facing up and locate the 4 retention tabs along the back edge of the keyboard

  • Slide the retention clips toward the keyboard to release the keyboard

コメントを追加する

Use a plastic pry tool to lift the rear edge of the keyboard. Pull  the keyboard slightly towards the display to disengage  the tabs along the front of the keyboard from the laptop palm rest. Lift the keyboard up to reveal the ribbon connectors
  • Use a plastic pry tool to lift the rear edge of the keyboard.

  • Pull the keyboard slightly towards the display to disengage the tabs along the front of the keyboard from the laptop palm rest.

  • Lift the keyboard up to reveal the ribbon connectors

After loosening the four moveable tabs at the screen end you simply pull slightly to the right to loosen the left side and then up to loose the five tabs in the lower end, then flip keyboard over so keys face the screen.

e5frog - 返信

Release the larger ribbon cable by flipping the brown retainer up so it is parallel with the ribbon cable Release the smaller ribbon cable by lifting up the white retainer I found it easier to reinstall both cables with the new keyboard resting on the back edge
  • Release the larger ribbon cable by flipping the brown retainer up so it is parallel with the ribbon cable

  • Release the smaller ribbon cable by lifting up the white retainer

  • I found it easier to reinstall both cables with the new keyboard resting on the back edge

There is no need at all to loosen any ribbon cables, after flipping keyboard so it faces keys against screen you can simply remove the RAM. Don't fiddle with the ribbon cables.

e5frog - 返信

Remove the two M2.0×4.0 broad-head screws. Remove the three Torx T8 M2.5×7.0 screws. Remove the three Torx T8 M2.5×7.0 screws.
  • Remove the two M2.0×4.0 broad-head screws.

  • Remove the three Torx T8 M2.5×7.0 screws.

コメントを追加する

Turn the computer over with the front toward you and the open the computer as far as possible. Release the ZIF connector for the power button board cable. Remove the switch cover by lifting it straight up and flip it forward.
  • Turn the computer over with the front toward you and the open the computer as far as possible.

  • Release the ZIF connector for the power button board cable.

  • Remove the switch cover by lifting it straight up and flip it forward.

  • Release the ZIF connector for the LED board cable.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Richdave

メンバー登録日: 2010年04月09日

27,897 ポイント

37のガイドは作成済み

チーム

Master Techs Master Techs人のメンバー

Community

277 メンバー

724のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 14

今までの合計 1,293