はじめに

Step-by-step guide to removing your phone's back plate.

パーツ

パーツは必要ありません。

  1. Flip phone to see back cover. Using either finger or spugder tool press button located  near the top of phone by the antenna.
    • Flip phone to see back cover.

    • Using either finger or spugder tool press button located near the top of phone by the antenna.

  2. Pry up back plate from phone to reveal battery. Push button near bottom of battery using either your finger of the spudger.  This will release the battery.
    • Pry up back plate from phone to reveal battery.

    • Push button near bottom of battery using either your finger of the spudger. This will release the battery.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  4. Using a T6 Torx Screwdriver remove the four torxs on the back of the phone.
    • Using a T6 Torx Screwdriver remove the four torxs on the back of the phone.

  5. Simultaneously press indicated buttons on both sides of phone. Simultaneously press indicated buttons on both sides of phone.
    • Simultaneously press indicated buttons on both sides of phone.

  6. Separate back plate from the rest of phone.
    • Separate back plate from the rest of phone.

    • Make sure to not pull, there is a wire (circled on image) connecting the two plates.

まとめ

To reassemble your device, follow these instructions in reverse order.

Elizabeth OBrien

メンバー登録日: 2010年04月26日

31 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 30-40, Garner Spring 2010 Cal Poly, Team 30-40, Garner Spring 2010人のメンバー

CPSU-GARNER-S10S30G40

4 メンバー

14のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 3,187