はじめに

After you remove the back cover, you can get to any part of your RoadMate.

パーツ

パーツは必要ありません。

Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth. Please note: this is a tedious process, but be patient.
  • Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth.

  • Please note: this is a tedious process, but be patient.

コメントを追加する

Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.
  • Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.

コメントを追加する

Open the back cover. Lift the cover slowly and carefully; the speaker is screwed on the back cover and is connected to the circuit board.
  • Open the back cover.

  • Lift the cover slowly and carefully; the speaker is screwed on the back cover and is connected to the circuit board.

コメントを追加する

Disconnect the speaker from the terminal. When reassembling, make sure that you plug the terminal in the same way.  The black wire should be on the side farthest from the battery.
  • Disconnect the speaker from the terminal.

  • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

In my 1200, the speaker is glued to the back and soldered into the board so there is no plug to undo. Just carefully find a position so that board doesn't pull on the speaker wire while it is open.

Jomar - 返信

where can we get the speakers from? please

bbunni1404 - 返信

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Ross Light

メンバー登録日: 2010年04月12日

175 ポイント

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 3,270