メインコンテンツにスキップ

はじめに

This guide will show you how to remove the CPU Cooler on your HP Compaq dx2000MT. If your CPU Cooler becomes damaged or stops working than you would need to replace it or if you need to remove the CPU Cooler to get to another part of the computer.

  1. Turn off your computer and remove the power cable by pulling it straight out of its socket.
    • Turn off your computer and remove the power cable by pulling it straight out of its socket.

  2. Remove the two Phillips #2 screws that secure the case door to the device. Remove the two Phillips #2 screws that secure the case door to the device.
    • Remove the two Phillips #2 screws that secure the case door to the device.

  3. Remove the side case door by pushing towards the rear of the device with your hand. This may take considerable force so keep pushing! Once you slide the door back, remove it by pulling it outwards from the device.
    • Remove the side case door by pushing towards the rear of the device with your hand.

    • This may take considerable force so keep pushing!

    • Once you slide the door back, remove it by pulling it outwards from the device.

  4. Remove the side case door by pushing towards the rear of the device with your hand. Once again, this may take considerable force. Once you slide the door back, remove it by pulling it outwards from the device.
    • Remove the side case door by pushing towards the rear of the device with your hand.

    • Once again, this may take considerable force.

    • Once you slide the door back, remove it by pulling it outwards from the device.

  5. Remove the 3 pin power connector by pulling it towards the side of the device. Remove the 3 pin power connector by pulling it towards the side of the device.
    • Remove the 3 pin power connector by pulling it towards the side of the device.

  6. Unscrew the 4 Torx T15 screws holding the CPU Cooler in place. Make sure to hold your cpu cooler when removing the screws. You don't want it to fall!
    • Unscrew the 4 Torx T15 screws holding the CPU Cooler in place.

    • Make sure to hold your cpu cooler when removing the screws. You don't want it to fall!

  7. Remove the cpu cooler by pulling out towards the side of the device. Make sure you do not touch where the cpu cooler makes contact with the processor! You could contaminate the layer of thermal paste that separates these components.
    • Remove the cpu cooler by pulling out towards the side of the device.

    • Make sure you do not touch where the cpu cooler makes contact with the processor! You could contaminate the layer of thermal paste that separates these components.

    • When replacing your cpu cooler, make sure you clean the processor contact area on the cooler and processor with isopropyl rubbing alcohol.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Logan Pace

メンバー登録日: 2011年10月12日

2,146 ポイント

9のガイドは作成済み

チーム

Cal Poly, Team 17-16, Regan Fall 2011 Cal Poly, Team 17-16, Regan Fall 2011人のメンバー

CPSU-REGAN-F11S17G16

4 メンバー

17のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 8

過去 30 日: 20

今までの合計 4,761