メインコンテンツにスキップ

RIDGID R84015 X2 Disassembly

必要な工具と部品

  1. RIDGID R84015 X2 Disassembly, RIDGID R84015 X2 Case Removal: 手順 1、 2の画像 1 RIDGID R84015 X2 Disassembly, RIDGID R84015 X2 Case Removal: 手順 1、 2の画像 2
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

  2. RIDGID R84015 X2 Disassembly: 手順 2、 1の画像 1
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

  3. RIDGID R84015 X2 Disassembly: 手順 3、 2の画像 1 RIDGID R84015 X2 Disassembly: 手順 3、 2の画像 2
    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

  4. RIDGID R84015 X2 Disassembly, RIDGID R84015 X2 Disassembly: 手順 4、 1の画像 1
    • With your drill taken apart, move your attention to the trigger and forward reverse switch.

  5. RIDGID R84015 X2 Disassembly: 手順 5、 1の画像 1
    • Check to see that the forward reverse switch isn't broken.

    • NOTE: small tab on trigger fits into groove on forward reverse switch

  6. RIDGID R84015 X2 Disassembly: 手順 6、 1の画像 1
    • With the battery attached, check that the wires work when the trigger is pulled.

    • Put multimeter wires here.

    • If wires work and drill doesn't, the problem is with the motor.

  7. RIDGID R84015 X2 Disassembly: 手順 7、 1の画像 1
    • Make sure plastic is not broken and switch is not stuck.

ゴール

2 の人々がこのガイドを完成させました。

作成者

6人の作成者と共同で作成されました。

Brian

メンバー登録日: 04/12/10

97 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 15-48, Garner Spring 2010 Cal Poly, Team 15-48, Garner Spring 2010人のメンバー

CPSU-GARNER-S10S15G48

6 メンバー

10のガイドは作成済み

コメント 1 件

I was able to diagnose and fix my problem with my black and decker following your instructions. TY

boxingchaos2011 - 返信

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 29

今までの合計 13,530