RICATECH-RTT22 Turntable Belt Replacement

はじめに

This fix shows you how to replace the belt of a RICATECH turntable. The belt is typically one of the first things to break on this device, so by replacing it you can extend the life of your player! This fix is very simple to do, just follow the steps.

http://www.ricatechstore.com/garantie-en... (new parts available)

For original spare parts, please contact:

+31(0)10-4626733

support@ricatech.com

必要な工具と部品

手順1 Belt

RICATECH-RTT22 Turntable Belt Replacement, Belt: 手順 1、 3の画像 1

RICATECH-RTT22 Turntable Belt Replacement, Belt: 手順 1、 3の画像 2

RICATECH-RTT22 Turntable Belt Replacement, Belt: 手順 1、 3の画像 3

Remove the arm holder by moving the needle to the side and lifting up.
Remove the rubber pad by lifting it up.

編集

手順2

RICATECH-RTT22 Turntable Belt Replacement: 手順 2、 3の画像 3

Flip over the record player. There should be screws (10mm phillips head) on the back.
Use your phillips head screwdriver to remove each screw (keep them in a safe place for later).

編集

手順3

RICATECH-RTT22 Turntable Belt Replacement: 手順 3、 3の画像 3

There will be three wires connecting the top to the bottom. Disconnect them carefully.
Put the back component of the record player to the side.

編集

手順4

RICATECH-RTT22 Turntable Belt Replacement: 手順 4、 3の画像 3

Use your phillips head screwdriver to remove the three screws (8mm phillips head) holding the motor in place.
Keep in mind that there is some pressure on the motor, since the belt holds together the motor and turntable.

編集

手順5

Unbolt (6mm bolt) the turntable from the housing using your wrench.
Since the turntable is designed to rotate, make sure the other side of the pin is kept from rotating while unbolting.

編集