メインコンテンツにスキップ

はじめに

In this guide, you will learn how to replace the rear camera on your device.

  1. Use a philips #00 screwdriver to unscrew both 4.064mm screws at the top of the device which hold it together. Use a philips #00 screwdriver to unscrew both 4.064mm screws at the top of the device which hold it together.
    • Use a philips #00 screwdriver to unscrew both 4.064mm screws at the top of the device which hold it together.

  2. Press a plastic opening tool into the space between the front and back portions of the case. Run it along the perimeter of the device to unhook the many plastic tabs.
    • Press a plastic opening tool into the space between the front and back portions of the case.

    • Run it along the perimeter of the device to unhook the many plastic tabs.

    • Gently pull both sides apart.

    • The speaker is connected to the back cover so be careful when separating

  3. Use a soldering iron to remove the soldered connections on the motherboard For your safety and to ensure a correct repair, be sure to exercise caution when using the soldering iron. For more information about soldering, check out this guide.
    • Use a soldering iron to remove the soldered connections on the motherboard

    • For your safety and to ensure a correct repair, be sure to exercise caution when using the soldering iron.

    • For more information about soldering, check out this guide.

  4. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  5. Use a philips #00 screwdriver to unscrew the three 4.064mm screws which attach the motherboard to the front of the device.
    • Use a philips #00 screwdriver to unscrew the three 4.064mm screws which attach the motherboard to the front of the device.

  6. Use your fingers to pop the three black tabs up to release the flat plastic data transfer cables. Use your fingers to pop the three black tabs up to release the flat plastic data transfer cables.
    • Use your fingers to pop the three black tabs up to release the flat plastic data transfer cables.

  7. Pull up the motherboard from the rest of the body.
    • Pull up the motherboard from the rest of the body.

  8. Using a spudger, gently pry off the camera from the back of the display
    • Using a spudger, gently pry off the camera from the back of the display

まとめ

To reassemble your device, follow these instructions in reverse order.

Stephen Radachy

メンバー登録日: 2015年03月17日

807 ポイント

5のガイドは作成済み

チーム

Michigan Tech, Team 1-5, Lauer Spring 2015 Michigan Tech, Team 1-5, Lauer Spring 2015人のメンバー

MTU-LAUER-S15S1G5

2 メンバー

12のガイドは作成済み

0 件のコメント

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 266