メインコンテンツにスキップ

QFX IT-437 Motherboard Replacement

必要な工具と部品

  1. QFX IT-437 Motherboard Replacement, Motherboard: 手順 1、 1の画像 1
    • Begin the process by using a PH00 Phillips screw driver.

    • Remove the two 1.2mm x 3mm screws at the bottom of the tablet.

  2. QFX IT-437 Motherboard Replacement: 手順 2、 2の画像 1 QFX IT-437 Motherboard Replacement: 手順 2、 2の画像 2
    • Use the iFixit plastic opening tool to pry open the back of the tablet.

    • Do not remove the back case completely as tape has to be removed from the wires, and pulling the case apart can tear off the wires.

  3. QFX IT-437 Motherboard Replacement: 手順 3、 1の画像 1
    • In order to unseat the motherboard, use the Phillips PH00 screw driver bit to remove the three 1.2mm x 3mm screws.

  4. QFX IT-437 Motherboard Replacement: 手順 4、 1の画像 1
    • Once the motherboard is loose, remove the tape above the SD card slot using an iFixit opening pick.

    • Be careful not to rip or damage the tape or else new tape will have to be used for the new motherboard.

  5. QFX IT-437 Motherboard Replacement: 手順 5、 1の画像 1
    • Use the spudger to remove the ribbon.

    • Avoid using too much force here or else the ribbon can be ripped.

  6. QFX IT-437 Motherboard Replacement: 手順 6、 1の画像 1
    • Use the spudger in the top corner of the tablet and lift the camera up.

  7. QFX IT-437 Motherboard Replacement: 手順 7、 1の画像 1
    • Lift the tape over the wires that are holding them to the tablet insulation.

  8. QFX IT-437 Motherboard Replacement: 手順 8、 1の画像 1
    • Pull out the motherboard and set it aside.

    • The wires must be soldered back on to the motherboard.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

作成者

4人の作成者と共同で作成されました。

Douglas

メンバー登録日: 01/28/15

482 ポイント

4のガイドは作成済み

チーム

Pasco Hernando, Team 5-2, Prince Winter 2015 Pasco Hernando, Team 5-2, Prince Winter 2015人のメンバー

PHSC-PRINCE-W15S5G2

6 メンバー

8のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 2

過去 7 日: 3

過去 30 日: 6

今までの合計 232