メインコンテンツにスキップ

はじめに

Is your drone controller not lighting up? A possible cause could be dead batteries. Follow these steps to learn how to replace the batteries. No tools are required because the screwdriver in included in the remote control.

  1. On the right side of the controller, slide the small screw driver out.
    • On the right side of the controller, slide the small screw driver out.

  2. Flip the controller over, so the black panels are facing up.
    • Flip the controller over, so the black panels are facing up.

  3. Unscrew the small screw on the left bottom side. The screw should be on the plastic piece that has an upwards facing arrow. Repeat for the screw on the bottom right hand side.
    • Unscrew the small screw on the left bottom side. The screw should be on the plastic piece that has an upwards facing arrow.

    • Repeat for the screw on the bottom right hand side.

  4. Pull the plastic piece off to reveal the compartment where the batteries go.
    • Pull the plastic piece off to reveal the compartment where the batteries go.

  5. Remove the old batteries.
    • Remove the old batteries.

まとめ

To reassemble your device, follow these instructions in reverse order.

Miranda Brinkley

メンバー登録日: 2018年10月22日

413 ポイント

3のガイドは作成済み

チーム

UC Davis, Team S11-G5, Lore Fall 2018 UC Davis, Team S11-G5, Lore Fall 2018人のメンバー

UCD-LORE-F18S11G5

3 メンバー

4のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 3

過去 7 日: 9

過去 30 日: 42

今までの合計 323