はじめに

In this guide we will open up the toaster and remove the old faulty power cord.

Make sure that the toaster is unplugged before attempting any sort of disassembly!
  • Make sure that the toaster is unplugged before attempting any sort of disassembly!

コメントを追加する

Grip the black plastic lever nub firmly and carefully remove it from the metal lever. Use one hand to hold the toaster in place while you pull the lever nub with the other.
  • Grip the black plastic lever nub firmly and carefully remove it from the metal lever. Use one hand to hold the toaster in place while you pull the lever nub with the other.

  • If this is the first time detaching this piece, it will take some effort to remove. Be careful as pulling too hard can cause damage to the inner lever mechanism.

コメントを追加する

  • Flipping the toaster upside down, use a T7 Torx Screwdriver to remove the four 10mm screws that keep the outer shell attached.

  • Flip the toaster back over and slide off the shell making sure to slip the toaster lever (now without the black plastic nub) through the lever opening in the shell.

  • The outer shell should now only be connected by its internal wiring.

コメントを追加する

  • Locate and remove the two 8mm screws that attach the circuit board (located inside of the shell) from the shell itself using the Phillips #2 screwdriver.

  • The shell should now be completely separated from the rest of the toaster.

コメントを追加する

  • Remove the small circuit board by pulling on the two side tabs while simultaneously releasing the middle clip.

  • Slide the small circuit board out of it's clips.

コメントを追加する

  • Using a Philips #2 screwdriver, remove the front two 8mm screws attaching the chassis to the base.

  • Flip the toaster around and proceed to remove the two remaining 8mm screws.

コメントを追加する

  • Upon removing the chassis, look in the toaster base to find the little white tab holding the power cord in place. Use a Philips screwdriver to remove the two 10mm screws.

コメントを追加する

  • De-solder the two power cord wires that are connected to the small circuit board.

  • Solder on replacement power cord.

  • If you're unsure of how to solder here is a helpful guide: Soldering Guide

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Zachary

メンバー登録日: 2014年01月23日

243 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 10-36, Maness Winter 2014 Cal Poly, Team 10-36, Maness Winter 2014人のメンバー

CPSU-MANESS-W14S10G36

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 383