メインコンテンツにスキップ

はじめに

Shows how to replace the entire power cord. This may need to be done if the device shut off mid-use. Be sure that the PopLite is unplugged from the wall and has had time after use to cool down before working on the device.

パーツ

パーツは指定されていません。

  1. Be sure that the popper is unplugged before disassembly.
    • Be sure that the popper is unplugged before disassembly.

    • Turn Presto Popper upside down.

  2. Remove the four 9 mm Phillips #2  screws from the base. Once all four screws are removed, take the base off. Once all four screws are removed, take the base off.
    • Remove the four 9 mm Phillips #2 screws from the base.

    • Once all four screws are removed, take the base off.

  3. Untwist the two orange twist-on wire connectors. Make a note of which wires are in each of the orange caps. Make a note of which wires are in each of the orange caps.
    • Untwist the two orange twist-on wire connectors.

    • Make a note of which wires are in each of the orange caps.

  4. Locate the plastic piece holding the power cord in place. Take the metal spudger from the tool kit and pry this piece loose. This plastic piece may take excessive force to pry out, just keep trying until it pops out.
    • Locate the plastic piece holding the power cord in place.

    • Take the metal spudger from the tool kit and pry this piece loose.

    • This plastic piece may take excessive force to pry out, just keep trying until it pops out.

    • Remove the power cord.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Emanuele Rocco

メンバー登録日: 2015年08月27日

694 ポイント

6のガイドは作成済み

チーム

USF Tampa, Team 2-5, Blackwell Fall 2015 USF Tampa, Team 2-5, Blackwell Fall 2015人のメンバー

USFT-BLACKWELL-F15S2G5

2 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 335