メインコンテンツにスキップ

Prerequisite

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. Prerequisite, Internal Hardware: 手順 1、 3の画像 1 Prerequisite, Internal Hardware: 手順 1、 3の画像 2 Prerequisite, Internal Hardware: 手順 1、 3の画像 3
    • Use a Torx T3 screwdriver to unscrew the four 3.5 mm Torx T3 screws holding the back plate.

    • Make sure the screws are kept in a safe place to insure they are not lost.

    • Remove the back plate.

  2. Prerequisite: 手順 2、 2の画像 1 Prerequisite: 手順 2、 2の画像 2
    • The plastic frame is clipped inside the steel body with four clips, two each on the left and the right side of the watch, near the corners. You can stick a small screwdriver into the cutouts right above the clips and gently lever the plastic frame up, corner by corner.

    • Once the clips are released, use a pair of tweezers to grab onto the black plastic frame and remove the internal hardware.

    • Adhesive on the back side of the battery holds the internal components to the front case.

    • Use tweezers or a plastic opening tool to disconnect the ribbon cable from the motherboard.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

5人の作成者と共同で作成されました。

Orlandria Heggs

メンバー登録日: 10/01/15

527 ポイント

3のガイドは作成済み

チーム

USF Tampa, Team 1-7, Leahy Fall 2015 USF Tampa, Team 1-7, Leahy Fall 2015人のメンバー

USFT-LEAHY-F15S1G7

3 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 77