メインコンテンツにスキップ

PowerBook G4 Titanium DVI DC-In Board Replacement

必要な工具と部品

  1. PowerBook G4 Titanium DVI DC-In Board Replacement, Battery: 手順 1、 2の画像 1 PowerBook G4 Titanium DVI DC-In Board Replacement, Battery: 手順 1、 2の画像 2
    • Locate the battery release tab on the underside of the G4.

    • Slide the battery release tab to the left and lift the battery out of the computer.

  2. PowerBook G4 Titanium DVI DC-In Board Replacement, Lower Case: 手順 2、 2の画像 1 PowerBook G4 Titanium DVI DC-In Board Replacement, Lower Case: 手順 2、 2の画像 2
    • Remove the seven T8 Torx screws from the lower case.

    • Using your thumbs, slide the lower case toward the front of the computer.

    • The lower case may stick in the front on a tab just above the center of the optical drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.

    • Lift the lower case off.

  3. PowerBook G4 Titanium DVI DC-In Board Replacement, DC-In Board: 手順 3、 1の画像 1
    • Disconnect the large DC-In connector from the right side of the logic board.

  4. PowerBook G4 Titanium DVI DC-In Board Replacement: 手順 4、 1の画像 1
    • Remove the two T6 Torx screws from the DC-In board.

  5. PowerBook G4 Titanium DVI DC-In Board Replacement: 手順 5、 1の画像 1
    • Lift the DC-In board out of the computer by pulling up and away from you.

    • If you don't have a 667 MHz computer, there is a fan in this location which makes it a bit difficult to remove the DC-In board.

    • If there is a fan present, rotate the DC-In board slightly clockwise before easing it out at a slight angle in order to clear the fan clamp on top of it.

終わりに

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

添付文書

作成者

5人の作成者と共同で作成されました。

iRobot

メンバー登録日: 09/24/09

1 ポイント

636のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 7

今までの合計 15,377