はじめに

Install an Airport Extreme 802.11g card internally.

  1. Use a coin to turn the battery locking screw 90 degrees to the right.
    • Use a coin to turn the battery locking screw 90 degrees to the right.

    • Lift the battery out of the computer.

    What can I say?

    It is certainly do able. I just completed it. Took me 2 hours. The most important tool you'll need is patience - bag full of patience!!

    Gopal - 返信

    Took 3 1/2 to 4 hours for someone who is handy but has never opened a computer before. Not so bad and it was a fun learning experience.

    Nomad Toes - 返信

    Quote from Nomad Toes:

    Took 3 1/2 to 4 hours for someone who is handy but has never opened a computer before. Not so bad and it was a fun learning experience.

    Weird. I posted this on Step 1 of replacing the optical drive, but it showed up on the RAM page since Step 1 is the same. Replacing the RAM takes 10 minutes.

    Nomad Toes - 返信

    I also see this on “replacing the battery” :-)

    atarixle -

    I guess, the hardest thing is to find a trustfully shop to buy a new one. You should create a manual how to disassemle the body of the battery and replace the standard round cells inside it.

    atarixle - 返信

  2. Flip down the door on the right side of the battery compartment.
    • Flip down the door on the right side of the battery compartment.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • Use a spudger or flathead screwdriver to disconnect the Airport antenna from the card.

    Note that this is a "right angle" coaxial connector. The metal cube is a part of the connector and stays with the cable. It is not a part of the airpor card. Also, I found two clear plastic blocks in front of the airport card, a smaller one near the connector and a larger one on the other side. Possibly these are to keep the cable from vibrating and flexing during, say, a truck ride. Don't lose these.

    jerrykrinock - 返信

    • Grasp the plastic tab and pull the card out all the way.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

20 の人々がこのガイドを完成させました。

添付文書

iRobot

メンバー登録日: 2009年09月24日

1 ポイント

623のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 5

過去 30 日: 17

今までの合計 19,737